Daniel H Coelho1, Taylor S Pence2, Mostafa Abdel-Hamid2, Richard M Costanzo3. 1. Department of Otolaryngology - Head & Neck Surgery, Virginia Commonwealth University School of Medicine, Richmond, VA, United States; Department of Physiology and Biophysics, Virginia Commonwealth University School of Medicine, Richmond, VA, United States. Electronic address: daniel.coelho@vcuhealth.org. 2. Department of Physiology and Biophysics, Virginia Commonwealth University School of Medicine, Richmond, VA, United States. 3. Department of Otolaryngology - Head & Neck Surgery, Virginia Commonwealth University School of Medicine, Richmond, VA, United States; Department of Physiology and Biophysics, Virginia Commonwealth University School of Medicine, Richmond, VA, United States.
Abstract
OBJECTIVE: All successful endonasal surgery, including functional endoscopic sinus surgery (FESS), depends on knowledge of both anatomy and the specific variations that can occur between and within patients. Familiarity with these structures is a critical component in preventing complications from these procedures, and failure to understand subtle variation can have disastrous results. The aim of this study was to characterize the anatomical variations (if any) of the cribriform plate using a large cadaveric sample set. Better understanding of the disparities within and between patients may have important implications for surgical planning. METHODS: Whole human skull specimens (31 specimens, 62 sides) were examined to obtain dimensional measurements of the cribriform plate on the right and left sides. RESULTS: The average length of the cribriform plate was 21.28mm (range 15.25-27.73mm, SD 3.30mm). The average width of the cribriform plate (including the crista galli) was 4.53mm (range 1.75-8.03mm, SD 1.20mm). When comparing side differences in individual specimens, there was more variability between widths, relative standard deviation 26.4%, than between lengths, relative standard deviation 15.5%. CONCLUSION: There is a range of both length and width of the cribriform plate, between and within individuals. This is particularly true for width. In practice, this emphasizes the importance of pre-operative imaging and recognition of anatomic variability for sinus or anterior skull base procedure.
OBJECTIVE: All successful endonasal surgery, including functional endoscopic sinus surgery (FESS), depends on knowledge of both anatomy and the specific variations that can occur between and within patients. Familiarity with these structures is a critical component in preventing complications from these procedures, and failure to understand subtle variation can have disastrous results. The aim of this study was to characterize the anatomical variations (if any) of the cribriform plate using a large cadaveric sample set. Better understanding of the disparities within and between patients may have important implications for surgical planning. METHODS: Whole human skull specimens (31 specimens, 62 sides) were examined to obtain dimensional measurements of the cribriform plate on the right and left sides. RESULTS: The average length of the cribriform plate was 21.28mm (range 15.25-27.73mm, SD 3.30mm). The average width of the cribriform plate (including the crista galli) was 4.53mm (range 1.75-8.03mm, SD 1.20mm). When comparing side differences in individual specimens, there was more variability between widths, relative standard deviation 26.4%, than between lengths, relative standard deviation 15.5%. CONCLUSION: There is a range of both length and width of the cribriform plate, between and within individuals. This is particularly true for width. In practice, this emphasizes the importance of pre-operative imaging and recognition of anatomic variability for sinus or anterior skull base procedure.