Literature DB >> 29331298

Spatiotemporal characterization of microdamage accumulation in rat ulnae in response to uniaxial compressive fatigue loading.

Xuhui Zhang1, Xiyu Liu2, Zedong Yan2, Jing Cai2, Fei Kang3, Shuai Shan4, Pan Wang2, Mingming Zhai2, X Edward Guo5, Erping Luo6, Da Jing7.   

Abstract

Repetitive fatigue loading can induce microdamage accumulation in bone matrix, which results in impaired mechanical properties and increased fracture susceptibility. However, the spatial distribution and time-variant process of microdamage accumulation in fatigue-loaded skeleton, especially for linear microcracks which are known to initiate bone remodeling, remain not fully understood. In this study, the time-varying process of the morphology and distribution of microcracks in rat ulnae subjected to uniaxial compressive fatigue loading was investigated. Right forelimbs of thirty four-month-old male Sprague-Dawley rats were subjected to one bout of cyclic ramp loading with 0.67 Hz at a normalized peak force of 0.055 N/g body weight for 6000 cycles, and the contralateral left ulnae were not loaded as the control samples. Ten rats were randomly euthanized on Days 3, 5, and 7 post fatigue loading. Our findings via two-dimensional histomorphometric measurements based on basic fuchsin staining and three-dimensional quantifications using contrast-enhanced micro-computed tomography (MicroCT) with precipitated BaSO4 staining demonstrated that the accumulation of linear microcracks (increase in the amount of linear microcracks) on Day 5 was significantly higher than that on Day 3 and Day 7 post fatigue loading. Our histological and histomorphometric results revealed that linear microcrack density (Cr.Dn) in the tensile cortex at Days 3, 5 and 7 post fatigue loading was significantly higher than that in the compressive side, whereas linear microcrack length (Cr.Le) in the tensile cortex at Day 3 was significantly lower than that in the compressive cortex. Our findings revealed that microcrack accumulation exhibited a non-linear time-varying process at 3, 5 and 7 days post axial compressive fatigue loading (with observable peak Cr.Dn at Day 5). Our findings also revealed distinct distribution of microcrack density and morphology in rat ulnae with tensile and compressive strains, as characterized by more microcracks accumulated in tensile cortices, and longer cracks shown in compressive cortices.
Copyright © 2018 Elsevier Inc. All rights reserved.

Entities:  

Keywords:  Bone remodeling; Fatigue loading; Linear microcrack; Microcrack density; Microcrack length; Microdamage

Mesh:

Year:  2018        PMID: 29331298     DOI: 10.1016/j.bone.2018.01.011

Source DB:  PubMed          Journal:  Bone        ISSN: 1873-2763            Impact factor:   4.398


  2 in total

1.  A New Biomimetic Composite Structure with Tunable Stiffness and Superior Toughness via Designed Structure Breakage.

Authors:  Xiaohan Wang; Dongxu Li
Journal:  Materials (Basel)       Date:  2020-01-31       Impact factor: 3.623

2.  A Single Axial Impact Load Causes Articular Damage That Is Not Visible with Micro-Computed Tomography: An Ex Vivo Study on Caprine Tibiotalar Joints.

Authors:  Robin P Blom; Douwe Mol; Leo J van Ruijven; Gino M M J Kerkhoffs; Theo H Smit
Journal:  Cartilage       Date:  2019-09-20       Impact factor: 3.117

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.