Primary angiographic success rates of percutaneous transluminal coronary angioplasty.

Three distinct periods in catheter design have been identified since the advent of percutaneous transluminal coronary angioplasty (PTCA) in 1977. In the first period PTCA was performed using a double-lumen balloon catheter that had a fixed, flexible guidewire at the tip. In the second period, an independent, steerable guidewire and the steerable catheter system were used. In the third period, low-profile catheters were introduced. A total of 2,969 patients who had single-vessel PTCA of a native coronary artery was separated into groups according to the period during which PTCA was performed. Introduction of the steerable catheter system was accompanied by improvement in primary success rate in PTCA attempts on the right coronary artery (78% vs 88%, p less than 0.005). Introduction of the low-profile catheter was accompanied by improved primary success in PTCA attempts on the left anterior descending coronary artery (LAD) (90% vs 94%, p less than 0.005). The percentage of PTCA attempts on the LAD decreased over the 3 periods (70% to 60% to 56%), while the percentage of attempts on the left circumflex artery increased (7% to 12% to 16%). Before steerable and low-profile catheters were used, there were significant differences in ability to reach and cross stenoses among the 3 major coronary arteries. These differences no longer exist. These results indicate that technical improvements and operator experience have made stenoses in all 3 major coronary arteries equally accessible to dilatation catheters and that primary success rates and reasons for failure in these arteries are now similar.