Distal femoropopliteal bypass using a composite graft of PTFE and non-reversed saphenous vein.

The results of femoropopliteal bypass to the infragenicular popliteal artery, in the absence of suitable saphenous vein have, in the main, been disappointing. We present a new type of composite graft, for use when the distal anastomosis is below the knee, which avoids the potential problems of prosthetic graft alone. The graft consists of a proximal segment of 6 mm expanded PTFE (Gore-Tex; or Impra), anastomosed to transposed non-reversed autologous saphenous vein. Forty-two patients were studied following unilateral, below knee composite femoropopliteal graft surgery for severe claudication or critical ischaemia. Pressure indices were calculated along with intraoperative flow rate, and all patients were followed up at regular intervals to assess graft patency. During the study period three patients died and graft occlusion occurred in a further eight. Analysis of the cumulative patency curve revealed that the majority of occlusions occurred in the first 3 months. The patency at 12 and 18 months was encouraging with values of 84% and 79% respectively. Comparison of pressure indices revealed a significant increase following surgery (P less than 0.001). The postoperative pressure index appeared to predict the grafts likely to occlude and the intraoperative flow rates mirrored a similar trend. Grafts which occluded had a significantly lower pressure index and flow rate (P less than 0.01, P less than 0.002, respectively). Our results suggest that for infragenicular femoropopliteal bypass grafting where full length in-situ vein graft is not possible; a composite graft using PTFE with non-reversed vein is a good alternative.