Investigations of medium-temperature heat treatments to achieve low outgassing rates in stainless steel ultrahigh vacuum chambers.

The authors investigated the outgassing rates and fluxes of vacuum chambers constructed from common 304L stainless steel vacuum components and subjected to heat treatments. Our goal was to obtain H2 outgassing flux on the order of 10-11 Pa l s-1cm-2 or better from standard stainless steel vacuum components readily available from a variety of manufacturers. The authors found that a medium-temperature bake in the range of 400 to 450°C, performed with the interior of the chamber under vacuum, was sufficient to produce the desired outgassing flux. The authors also found that identical vacuum components baked in air at the same temperature for the same amount of time did not produce the same low outgassing flux. In that case, the H2 outgassing flux was lower than that of a stainless-steel chamber with no heat treatment, but was still approximately 1 order of magnitude higher than that of the medium-temperature vacuum-bake. Additionally, the authors took the chamber that was subjected to the medium-temperature vacuum heat treatment and performed a 24-h air bake at 430°C. This additional heat treatment lowered the outgassing rate by nearly a factor of two, which strongly suggests that the air-bake created an oxide layer which reduced the hydrogen recombination rate on the surface. [http://dx.doi.org/10.1116/1.4983211].