Oana Dragan1, Ioan Tomuta2, Dorina Casoni3, Costel Sarbu3, Radu Campian1, Tiberiu Frentiu4. 1. Department of Oral Rehabilitation, Faculty of Dentistry, University of Medicine and Pharmacy, Cluj-Napoca, Romania. 2. Department of Pharmaceutical Technology and Biopharmaceutics, Faculty of Pharmacy, University of Medicine and Pharmacy, Cluj-Napoca, Romania. 3. Department of Chemistry, Faculty of Chemistry and Chemical Engineering, Babes-Bolyai University, Cluj-Napoca, Romania. 4. Department of Chemistry, Faculty of Chemistry and Chemical Engineering, Babes-Bolyai University, Cluj-Napoca, Romania. Electronic address: ftibi@chem.ubbcluj.ro.
Abstract
INTRODUCTION: This article reports for the first time the effects of multiple additives (polyethylene glycol 400, Triton X-100, benzalkonium chloride, and ethyl formate) on the surface tension, pH, and viscosity of 5.25% sodium hypochlorite (NaOCl) irrigant solution. Advanced statistical approaches based on unsupervised multivariate analysis (cluster analysis and principal component analysis) were used to quantify the variability of the physicochemical properties of the modified NaOCl solution for the first time in dentistry. METHODS: Solutions of 5.25% NaOCl were modified with multiple additives in various concentrations, physicochemical parameters were measured at 22°C and 37°C, and the results were statistically analyzed to group the solutions and reveal the effects of additives. RESULTS: Cluster analysis and principal component analysis revealed that pH and surface tension were the significant parameters (P < .05) for grouping the modified solutions. Four principal components, accounting for 90.6% of the total variance, were associated with flow characteristics (37.3%) determined by polyethylene glycol; the wetting property (22.5% and 10.5%), which was dependent on cationic and nonionic surfactant; and the antimicrobial effect (20.3%) influenced by ethyl formate. Varimax rotation of the principal components showed that the cationic surfactant (benzalkonium chloride) had significantly decreased surface tension compared with the nonionic surfactant (Triton-X). Although ethyl formate was introduced as an odor modifier, it had a significant effect on pH decrease and the occurrence of effervescence with O2 and hypochlorous acid release. CONCLUSIONS: The statistical results revealed that the 5.25% NaOCl irrigant solution should be modified with a mixture of 0.1% benzalkonium chloride, 1% ethyl formate, and 7% polyethylene glycol for obtaining a low pH and low surface tension.
INTRODUCTION: This article reports for the first time the effects of multiple additives (polyethylene glycol 400, Triton X-100, benzalkonium chloride, and ethyl formate) on the surface tension, pH, and viscosity of 5.25% sodium hypochlorite (NaOCl) irrigant solution. Advanced statistical approaches based on unsupervised multivariate analysis (cluster analysis and principal component analysis) were used to quantify the variability of the physicochemical properties of the modified NaOCl solution for the first time in dentistry. METHODS: Solutions of 5.25% NaOCl were modified with multiple additives in various concentrations, physicochemical parameters were measured at 22°C and 37°C, and the results were statistically analyzed to group the solutions and reveal the effects of additives. RESULTS: Cluster analysis and principal component analysis revealed that pH and surface tension were the significant parameters (P < .05) for grouping the modified solutions. Four principal components, accounting for 90.6% of the total variance, were associated with flow characteristics (37.3%) determined by polyethylene glycol; the wetting property (22.5% and 10.5%), which was dependent on cationic and nonionic surfactant; and the antimicrobial effect (20.3%) influenced by ethyl formate. Varimax rotation of the principal components showed that the cationic surfactant (benzalkonium chloride) had significantly decreased surface tension compared with the nonionic surfactant (Triton-X). Although ethyl formate was introduced as an odor modifier, it had a significant effect on pH decrease and the occurrence of effervescence with O2 and hypochlorous acid release. CONCLUSIONS: The statistical results revealed that the 5.25% NaOCl irrigant solution should be modified with a mixture of 0.1% benzalkonium chloride, 1% ethyl formate, and 7% polyethylene glycol for obtaining a low pH and low surface tension.