Hitoshi Nakashima1, Jyunya Takahashi1, Nobuyuki Fujii1, Tsutomu Okuno2. 1. Polytechnic University, Faculty of Human Resources Development, 2-32-1 Ogawa-nishimachi, Kodaira-shi, Tokyo 187-0035, Japan. 2. Department of Electrical & Electronic Engineering, Graduate School of Science and Engineering, Tokyo Metropolitan University; Human Engineering and Risk Management Research Group, National Institute of Occupational Safety and Health, 1-1 Minamiosawa, Hachioji, Tokyo 192-0397, Japan.
Abstract
OBJECTIVES: The objective was to quantify the blue-light hazard from gas metal arc welding (GMAW) of aluminum alloys. The exposure level is expected to depend on the welding conditions. Therefore, it is important to identify the blue-light hazard under various welding conditions. METHODS: We experimentally conducted GMAW of aluminum alloys under various welding conditions and measured the spectral radiance of the arcs. The effective blue-light radiance, which the American Conference of Governmental Industrial Hygienists has defined to quantify the exposure level of blue light, was calculated from the measured spectral radiance. The maximum acceptable exposure duration per 10000 s for this effective blue-light radiance was calculated. RESULTS: The effective blue-light radiance measured in this study was in the range of 2.9-20.0 W cm-2·sr. The corresponding maximum acceptable exposure duration per 10000 s was only 5.0-34 s, so it is hazardous to view the welding arc. The effective blue-light radiance was higher at higher welding currents than at lower welding currents, when pulsed welding currents were used rather than steady welding currents, and when magnesium was included in the welding materials. CONCLUSIONS: It is very hazardous to view the arcs in GMAW of aluminum alloys. Welders and their helpers should use appropriate eye protection in arc-welding operations. They should also avoid direct light exposure when starting an arc-welding operation.
OBJECTIVES: The objective was to quantify the blue-light hazard from gas metal arc welding (GMAW) of aluminum alloys. The exposure level is expected to depend on the welding conditions. Therefore, it is important to identify the blue-light hazard under various welding conditions. METHODS: We experimentally conducted GMAW of aluminum alloys under various welding conditions and measured the spectral radiance of the arcs. The effective blue-light radiance, which the American Conference of Governmental Industrial Hygienists has defined to quantify the exposure level of blue light, was calculated from the measured spectral radiance. The maximum acceptable exposure duration per 10000 s for this effective blue-light radiance was calculated. RESULTS: The effective blue-light radiance measured in this study was in the range of 2.9-20.0 W cm-2·sr. The corresponding maximum acceptable exposure duration per 10000 s was only 5.0-34 s, so it is hazardous to view the welding arc. The effective blue-light radiance was higher at higher welding currents than at lower welding currents, when pulsed welding currents were used rather than steady welding currents, and when magnesium was included in the welding materials. CONCLUSIONS: It is very hazardous to view the arcs in GMAW of aluminum alloys. Welders and their helpers should use appropriate eye protection in arc-welding operations. They should also avoid direct light exposure when starting an arc-welding operation.
Authors: George A Gourzoulidis; Efthymios Karabetsos; Constantinos Bourousis; Charilaos Tyrakis; Andreas D Flouris; Thomas G Maris; Frangiskos V Topalis Journal: Med Lav Date: 2022-04-26 Impact factor: 1.275