| Literature DB >> 28726128 |
Abstract
Using a time-dependent phosphorus (P) budget model for the Baltic proper, describing sources and sinks at the external borders of the water column, one may compute the e-folding time T of the adjustment of the winter surface water P concentration c 1 to abruptly changed total P supply. The restoration time TR = 3T is introduced as a practical measure of the time it takes to achieve 95% of the change of c 1 towards the final, equilibrium, state c 1e. The P budget model, including an internal source emanating from deep anoxic bottoms, also shows that c 1e is proportional to the total P supply to the water column. About 70% of present time total P supply to the Baltic proper comes from deep anoxic bottoms. If deep bottoms were kept oxygenated, this internal P supply would be turned off and the equilibrium concentration c1e would be reduced by about 70%. This should imply that the Baltic proper may be restored to a state determined by the external P supplies from land-based and oceanic sources. According to the model, restoration would take 10-15 years. Thereafter most of the equipment used for oxygenation may be shut off since also the deepwater oxygen demand by decomposition of fresh organic matter, would have decreased by about 70% implying that the deepwater would be kept oxic by the natural vertical circulation. The model presented in this paper provides a new science-based solution of the eutrophication problem of the Baltic proper, which is of great interest from a management point of view.Entities:
Keywords: Anoxic conditions; Baltic Sea; Internal source; P; Phosphorus model; Restoration
Mesh:
Substances:
Year: 2017 PMID: 28726128 PMCID: PMC5709262 DOI: 10.1007/s13280-017-0933-7
Source DB: PubMed Journal: Ambio ISSN: 0044-7447 Impact factor: 5.129
Fig. 1Map of the Baltic Sea
Fig. 2The content of P below 60 m (solid line) and the area of anoxic bottoms in the Baltic proper (broken line). (From Stigebrandt et al. 2014)
Fig. 3Volume of hypoxic (0 < O2 < 2 mL L−1) and anoxic (no oxygen) bottom water, observations obtained in the period August to October, in the Baltic proper, including Gulf of Riga and Gulf of Finland, from 1960 to 2015. Results from 1961 and 1967 were omitted due to lack of data from the deep basins. Redrawn from Hansson and Andersson (2017)
Fig. 4Phosphorus model of a two-layered Baltic Sea with winter concentrations c 1 and c 2, in the upper and lower layers, respectively (Stigebrandt et al. 2014). The stippled line indicates the horizontal surface of area A 2 separating the upper and lower layers (the halocline). The P concentration, c 0, in Kattegat, outside the entrance sills is further discussed below Eq. (1). Q f is the rate of freshwater supply, Q 1 the rate of inflow of new deepwater from Kattegat and Q the flow rate of surface water that is entrained into the inflowing new deepwater. The vertical exchange of P between the layers is due to (downward) export of new production NP and surface water mixed into the new deepwater from Kattegat and (upward) transport of lower layer water into the surface layer due to entrainment in winter at the mean rate Q 1 + Q e. Internal sources and sinks associated to the seabed are also marked
List of symbols
|
| Integration constant |
|
| Horizontal surface area of the Baltic proper |
|
| Horizontal surface separating the two layers, c.f. Fig. 4 |
|
| Area of anoxic bottoms |
|
| Area of defaunated bottoms (before oxygenation starts) |
|
| Integration constant |
|
| Mean winter P concentration in the volume V |
|
| Winter P concentration in the surface layer |
|
| Annual mean P concentration in the surface layer |
|
| Equilibrium winter surface P concentration |
|
| Initial winter surface P concentration (at the start of restoration) |
|
| Winter P concentration in the lower layer |
|
| Time mean P concentration of inflowing new deepwater from Kattegat |
| Extsource [tonnes P year−1] | External land-based P source |
|
| Temporal and spatial mean specific DIP flux from anoxic bottoms |
| Intsink [tonnes P year−1] | Total Internal sink of P, defined by Eq. (2), c.f. Fig. 4 |
| Intsource [tonnes P year−1] | Internal P source from anoxic bottoms |
| NP [tonnes P year−1] | Net production |
|
| Rate of inflow of new deepwater from Kattegat, c.f. Fig. 4 |
|
| External oceanic P source (P inflow from Kattegat) |
|
| Rate of entrained surface water into the new deepwater, c.f. Fig. 4 |
|
| Rate of freshwater supply, c.f. Fig. 4 |
|
| Time |
|
| Time constant for the adjustment process |
| Totsource [tonnes P year−1] | Equals Extsource + |
| TR [year] | Restoration time defined as TR = 3 |
| TRVF [km3 year−1] | Total Removal Volume Flux |
|
| Total Volume of Baltic proper |
|
| Volume of upper (lower) layer |
|
| Apparent settling velocity |
|
| Substitution variable used for solving Eq. (7) |
|
| Fraction (0 ≤ |
|
| Fraction (0 ≤ |
|
| Ratio |
|
| Fraction (0 ≤ |
Column 2 shows parameter values valid for 1980 for evaluation of TRVF
Adopted from Stigebrandt et al. 2014)
|
| 0.8 | Surface winter concentration, observed |
| Extsource (tonnes P year−1) | 60 000 | External land-based source |
| Intsource (tonnes P year−1) | 46 000 | Internal source |
|
| 5000 | Annual storage change |
|
| 11 000 | External oceanic source |
|
| 450 | Freshwater supply |
|
| 450 | Inflow from Kattegat |
|
| 0.8 | Concentration factor |
Fig. 5The equilibrium winter surface concentration c 1e (TP) versus the total P supply to the Baltic proper computed using Eq. (4)
Fig. 6Adjustment of the winter surface layer concentration c 1 towards the equilibrium concentration c1e for two cases described in “The adjustment time to changed total P supply” section and the “BSAP case” described in “The equilibrium solution” and “Response time of the winter surface concentration of P to changed total supply of P” sections
The observed TP concentration c 1o (column 3) in the winter surface water in the Baltic proper and the modeled, equilibrium concentration from Eq. (4), c 1e (column 4). The observed concentrations are from “Introduction” section of the present paper. The Total P loading Totsource (column 2) equals the sum of land-based and ocean-based external sources and the internal source, is obtained from numbers given by Stigebrandt et al. (2014)
| Year | Totsource (tonnes P year−1) |
|
|
|---|---|---|---|
| 1958 | 45 000 | 0.27 | 0.32 |
| 1980 | 117 000 | 0.80 | 0.83 |
| 2010 | 140 000 | 1.00 | 1.00 |