Literature DB >> 28711304

Comparing REACH Chemical Safety Assessment information with practice-a case-study of polymethylmethacrylate (PMMA) in floor coating in The Netherlands.

Ton Spee1, Daan Huizer2.   

Abstract

On June 1st, 2007 the European regulation on Registration, Evaluation and Restriction of Chemical substances (REACH) came into force. Aim of the regulation is safe use of chemicals for humans and for the environment. The core element of REACH is chemical safety assessment of chemicals and communication of health and safety hazards and risk management measures throughout the supply chain. Extended Safety Data Sheets (Ext-SDS) are the primary carriers of health and safety information. The aim of our project was to find out whether the actual exposure to methyl methacrylate (MMA) during the application of polymethylmethacrylate (PMMA) in floor coatings as assessed in the chemical safety assessment, reflect the exposure situations as observed in the Dutch building practice. Use of PMMA flooring and typical exposure situations during application were discussed with twelve representatives of floor laying companies. Representative situations for exposure measurements were designated on the basis of this inventory. Exposure to MMA was measured in the breathing zone of the workers at four construction sites, 14 full shift samples and 14 task based samples were taken by personal air sampling. The task-based samples were compared with estimates from the Targeted Risk Assessment Tool (v3.1) of the European Centre for Ecotoxicology and Toxicology of Chemicals (ECETOC-TRA) as supplied in the safety assessment from the manufacturer. For task-based measurements, in 12 out of 14 (86%) air samples measured exposure was higher than estimated exposure. Recalculation with a lower ventilation rate (50% instead of 80%) together with a higher temperature during mixing (40°C instead of 20°C) in comparison with the CSR, reduced the number of underestimated exposures to 10 (71%) samples. Estimation with the EMKG-EXPO-Tool resulted in unsafe exposure situations for all scenarios, which is in accordance with the measurement outcomes. In indoor situations, 5 out of 8 full shift exposures (62%) to MMA were higher than the Dutch occupational exposure limit of 205mg/m3 (8h TWA), which equals the DNEL. For semi-enclosed situations this was 1 out of 6 (17%). Exposures varied from 31 to 367mg/m3. The results emphasize that ECETOC-TRA exposure estimates in poorly controlled situations need better underpinning.
Copyright © 2017 Elsevier GmbH. All rights reserved.

Entities:  

Keywords:  Exposure measurement; Exposure modelling; Methyl methacrylate; Occupational exposure; Risk management measures

Mesh:

Substances:

Year:  2017        PMID: 28711304     DOI: 10.1016/j.ijheh.2017.05.012

Source DB:  PubMed          Journal:  Int J Hyg Environ Health        ISSN: 1438-4639            Impact factor:   5.840


  5 in total

Review 1.  Validity of Tier 1 Modelling Tools and Impacts on Exposure Assessments within REACH Registrations-ETEAM Project, Validation Studies and Consequences.

Authors:  Urs Schlueter; Martin Tischer
Journal:  Int J Environ Res Public Health       Date:  2020-06-26       Impact factor: 3.390

Review 2.  Solid Wastes Provide Breeding Sites, Burrows, and Food for Biological Disease Vectors, and Urban Zoonotic Reservoirs: A Call to Action for Solutions-Based Research.

Authors:  Amy Krystosik; Gathenji Njoroge; Lorriane Odhiambo; Jenna E Forsyth; Francis Mutuku; A Desiree LaBeaud
Journal:  Front Public Health       Date:  2020-01-17

3.  Comparison between Communicated and Calculated Exposure Estimates Obtained through Three Modeling Tools.

Authors:  Andrea Spinazzè; Francesca Borghi; Daniele Magni; Costanza Rovida; Monica Locatelli; Andrea Cattaneo; Domenico Maria Cavallo
Journal:  Int J Environ Res Public Health       Date:  2020-06-11       Impact factor: 3.390

4.  How to Obtain a Reliable Estimate of Occupational Exposure? Review and Discussion of Models' Reliability.

Authors:  Andrea Spinazzè; Francesca Borghi; Davide Campagnolo; Sabrina Rovelli; Marta Keller; Giacomo Fanti; Andrea Cattaneo; Domenico Maria Cavallo
Journal:  Int J Environ Res Public Health       Date:  2019-08-02       Impact factor: 3.390

Review 5.  The ECETOC-Targeted Risk Assessment Tool for Worker Exposure Estimation in REACH Registration Dossiers of Chemical Substances-Current Developments.

Authors:  Jan Urbanus; Oliver Henschel; Qiang Li; Dave Marsh; Chris Money; Dook Noij; Paul van de Sandt; Joost van Rooij; Matthias Wormuth
Journal:  Int J Environ Res Public Health       Date:  2020-11-14       Impact factor: 3.390

  5 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.