Evaluation of different surface treatments on fiber post cemented with a self-adhesive system.

Surface treatment of fiber-reinforced posts can increase adhesion, especially on the post/resin cement interface. The purpose of this in vitro study was to evaluate the effect of different surface treatments on fiber post cemented with a self-adhesive system. Sixty fiberglass epoxy resin posts were cleaned, dried and divided into 6 groups (n=10): Control (no surface treatment), silane (silane coupling agent was applied homogeneously on surface), 24% hydrogen peroxide (H2O2) (immersion during 1min), blasting (blasting with aluminum oxide for 30s), NH3 plasma (plasma treatment for 3min) and HMDSO plasma (plasma treatment for 15min). After the treatments, posts were inserted into a silicon matrix that was filled with the resin cement RelyX U200. Afterwards, the post/cement specimens were cut perpendicularly to the long axis of the posts into six 1.0mm thick discs and submitted to a push-out bond strength (POBS) test. Failure pattern was classified in 5 types: type I: cohesive in post; type II: cohesive in cement; type III: cohesive post and cement; type IV: adhesive post/cement; and type V: mixed (association between cohesive and adhesive). Data were analyzed by one-way ANOVA and Tukey HSD post hoc test (α=0.05). Silane (15.94±6.5), blasting (13.13±3.6), NH3 plasma (14.44±4.0) and HMDSO plasma (13.23±5.3) showed higher POBS when compared to control (p<0.05) and similar among them. H2O2 (9.40±4.0) treatment showed POBS values statistically similar to control (9.65±3.6). Failures were predominantly cohesive post and cement, type III, in all groups. In conclusion, surface treatments influenced in the adhesion of fiberglass post with the self-adhesive cement RelyX U200. Silane, blasting with aluminum oxide and plasmas (NH3 and HMDSO) showed results superior to 24% hydrogen peroxide.