Literature DB >> 28427623

Degradation of reactive blue 13 using hydrodynamic cavitation: Effect of geometrical parameters and different oxidizing additives.

Sunil Rajoriya1, Swapnil Bargole1, Virendra Kumar Saharan2.   

Abstract

Decolorization of reactive blue 13 (RB13), a sulphonated azo dye, was investigated using hydrodynamic cavitation (HC). The aim of research article is to check the influence of geometrical parameters (total flow area, the ratio of throat perimeter to its cross-sectional area, throat shape and size, etc.) and configuration of the cavitating devices on decolorization of RB13 in aqueous solution. For this purpose, eight cavitating devices i.e. Circular and slit venturi, and six orifice plates having different flow area and perimeter were used in the present work. Initially, the effects of various operating parameters such as solution pH, initial dye concentration, operating inlet pressure and cavitation number on the decolorization of RB13 have been investigated, and the optimum operating conditions were found. Kinetic analysis revealed that the decolorization and mineralization of RB13 using HC followed first order reaction kinetics. Almost 47% decolorization of RB13 was achieved using only HC with slit venturi as a cavitating device at an optimum inlet pressure of 0.4MPa and pH of the solution as 2.0. It has been found that in case of orifice plates, higher decolorization rate of 4×10-3min-1 was achieved using orifice plate 2 (OP2) which is having higher flow area and perimeter (α=2.28). The effect of process intensifying agents (hydrogen peroxide and ferrous sulphate) and different gaseous additives (oxygen and ozone) on the extent of decolorization of RB13 were also examined. Almost 66% decolorization of RB13 was achieved using HC combined with 2Lmin-1 of oxygen and in combination with ferrous sulphate (1:3). Nearly 91% decolorization was achieved using HC combined with H2O2 at an optimum molar ratio (dye:H2O2) of 1:20 while almost complete decolorization was observed in 15min using a combination of HC and ozone at 3gh-1 ozone feed rate. Maximum 72% TOC was removed using HC coupled with 3gh-1 ozone feed rate.
Copyright © 2017 Elsevier B.V. All rights reserved.

Entities:  

Keywords:  Decolorization; Gaseous additives; Hydrodynamic cavitation; Reactive Blue 13; Venturi and orifice geometry

Year:  2017        PMID: 28427623     DOI: 10.1016/j.ultsonch.2017.01.005

Source DB:  PubMed          Journal:  Ultrason Sonochem        ISSN: 1350-4177            Impact factor:   7.491


  3 in total

Review 1.  A critical review of the current technologies in wastewater treatment plants by using hydrodynamic cavitation process: principles and applications.

Authors:  Giuseppe Mancuso; Michela Langone; Gianni Andreottola
Journal:  J Environ Health Sci Eng       Date:  2020-01-27

2.  Design and optimization of a cavitating device for Congo red decolorization: Experimental investigation and CFD simulation.

Authors:  Zahra Abbas-Shiroodi; Mohammad-Taghi Sadeghi; Soroush Baradaran
Journal:  Ultrason Sonochem       Date:  2020-11-13       Impact factor: 7.491

3.  Degradation of benzene present in wastewater using hydrodynamic cavitation in combination with air.

Authors:  Pooja Thanekar; Parag R Gogate; Z Znak; Yu Sukhatskiy; R Mnykh
Journal:  Ultrason Sonochem       Date:  2020-07-31       Impact factor: 7.491

  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.