Literature DB >> 27839796

Osteosynthesis for clavicle fractures: How close are we to penetration of neurovascular structures?

A Stillwell1, C Ioannou2, L Daniele2, S L E Tan3.   

Abstract

INTRODUCTION: Risks associated with drill plunging are well recognised in clavicle osteosynthesis. To date no studies have described plunge depth associated with clavicle osteosynthesis. PRIMARY AIM: To determine whether plunge depth associated with clavicle osteosynthesis is great enough to penetrate neurovascular structures and whether surgical experience reduces the risk of neurovascular injury
METHOD: Cadaveric clavicles were pressed into spongy phenolic foam to allow measurement of drill bit penetration beyond the far cortex (plunge depth). 15 surgeons grouped according to experience were asked to drill a single hole in the medial, middle and lateral clavicle in 2 specimens each. Each surgeon used fully a charged standard Stryker drill with a new 2.6mm drill bit and guide. Plunge depths were measured in 0.5mm increments. Depth measurements were compared amongst groups and to previously documented distances to neurovascular structures as outlined by Robinson et al. Kruskal-Wallis test was used for overall comparison and Mann-Whitney U test was used for comparing the groups individually.
RESULTS: Mean plunge depth across all groups was 3.4mm, (0.5-6.5), 4.0mm (1mm-8.5mm) and 4.0mm (0.5mm-15mm) in the medial, middle and lateral clavicle. Plunge depths were greater than previously documented distances to the subclavian vein at the medial clavicle on nine occasions. Plunge depths in the middle and lateral clavicle were well within the previously documented distances from neurovascular structures. There was no correlation between level of experience and median plunge depth (p=0.18). However, inexperienced surgeons plunged 1mm greater than intermediate and experienced surgeons (p=0.026). There was one significant outlier; a 15mm plunge depth by an inexperienced surgeon in the lateral clavicle.
CONCLUSION: Clavicle osteosynthesis has a relatively high risk of neurovascular injury. Plunge depths through the clavicle often exceed the distance of neurovascular structures, especially in the medial clavicle. A thorough understanding of the anatomy of these neurovascular structures and methods to prevent excessive plunging is important prior to undertaking clavicle osteosynthesis.
Copyright © 2016 Elsevier Ltd. All rights reserved.

Entities:  

Keywords:  Clavicle fracture; Clavicle osteosynthesis; Internal fixation; Neurovascular injury; Plating; Plunge depth; Surgical complication; Surgical experience; Trauma

Mesh:

Year:  2016        PMID: 27839796     DOI: 10.1016/j.injury.2016.10.044

Source DB:  PubMed          Journal:  Injury        ISSN: 0020-1383            Impact factor:   2.586


  4 in total

1.  The distributed pattern of the neurovascular structures around clavicle to minimize structural injury in clinical field: anatomical study.

Authors:  Anna Jeon; Chang Min Seo; Je-Hun Lee; Seung-Ho Han
Journal:  Surg Radiol Anat       Date:  2018-08-27       Impact factor: 1.246

2.  Screws are at a safe distance from critical structures after superior plate fixation of clavicle fractures.

Authors:  Joshua A Parry; Lori R Chambers; Kenneth J Koval; Joshua R Langford
Journal:  Eur J Orthop Surg Traumatol       Date:  2019-09-09

3.  [Effectiveness analysis of distal radius microplate locking plate for treatment of displaced fracture of medial clavicle].

Authors:  Jinyuan Zeng; Junjian Ye; Yun Xie; Chunyong Chen; Zhangxiong Lin
Journal:  Zhongguo Xiu Fu Chong Jian Wai Ke Za Zhi       Date:  2019-05-15

4.  Power-Tool Use in Orthopaedic Surgery: Iatrogenic Injury, Its Detection, and Technological Advances: A Systematic Review.

Authors:  Matthew C A Arnold; Sarah Zhao; Ruben J Doyle; Jonathan R T Jeffers; Oliver R Boughton
Journal:  JB JS Open Access       Date:  2021-11-19
  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.