Jon Thacker1, Jeff L Zhang2, Tammy Franklin3, Pottumarthi Prasad3,4. 1. Biomedical Engineering, Northwestern University, Evanston, Illinois, USA. 2. Department of Radiology, University of Utah, Salt Lake City, Utah, USA. 3. Department of Radiology/Center for Advanced Imaging, NorthShore University HealthSystem, Evanston, Illinois, USA. 4. Department of Radiology, Pritzker School of Medicine, University of Chicago, Chicago, Illinois, USA.
Abstract
PURPOSE: Blood oxygen level-dependent (BOLD) MRI has been effectively used to monitor changes in renal oxygenation. However, R2* (or T2*) is not specific to blood oxygenation and is dependent on other factors. This study investigates the use of a statistical model that takes these factors into account and maps BOLD MRI measurements to blood pO2. METHODS: Spin echo and gradient echo images were obtained in six Sprague-Dawley rats and R2 and R2* maps were computed. Measurements were made at baseline, post-nitric oxide synthase inhibitor (L-NAME), and post-furosemide administration. A simulation of each region was performed to map R2' (computed as R2*-R2) to blood pO2. RESULTS: At baseline, blood pO2 in the outer medulla was 30.5 ± 1.2 mmHg and 51.9 ± 5.2 mmHg in the cortex, in agreement with previous invasive studies. Blood pO2 was found to decrease within the outer medulla following L-NAME (P < 0.05) and increase after furosemide (P < 0.05). Blood pO2 in the cortex increased following furosemide (P < 0.05). CONCLUSIONS: Model-derived blood pO2 is sensitive to pharmacological challenges, and baseline pO2 is comparable to literature values. Reporting pO2 instead of R2* could lead to a greater clinical impact of renal BOLD MRI and facilitate the identification of hypoxic regions. Magn Reson Med 78:297-302, 2017.
PURPOSE: Blood oxygen level-dependent (BOLD) MRI has been effectively used to monitor changes in renal oxygenation. However, R2* (or T2*) is not specific to blood oxygenation and is dependent on other factors. This study investigates the use of a statistical model that takes these factors into account and maps BOLD MRI measurements to blood pO2. METHODS: Spin echo and gradient echo images were obtained in six Sprague-Dawley rats and R2 and R2* maps were computed. Measurements were made at baseline, post-nitric oxide synthase inhibitor (L-NAME), and post-furosemide administration. A simulation of each region was performed to map R2' (computed as R2*-R2) to blood pO2. RESULTS: At baseline, blood pO2 in the outer medulla was 30.5 ± 1.2 mmHg and 51.9 ± 5.2 mmHg in the cortex, in agreement with previous invasive studies. Blood pO2 was found to decrease within the outer medulla following L-NAME (P < 0.05) and increase after furosemide (P < 0.05). Blood pO2 in the cortex increased following furosemide (P < 0.05). CONCLUSIONS: Model-derived blood pO2 is sensitive to pharmacological challenges, and baseline pO2 is comparable to literature values. Reporting pO2 instead of R2* could lead to a greater clinical impact of renal BOLD MRI and facilitate the identification of hypoxic regions. Magn Reson Med 78:297-302, 2017.
Authors: Jeff L Zhang; Glen Morrell; Henry Rusinek; Lizette Warner; Pierre-Hugues Vivier; Alfred K Cheung; Lilach O Lerman; Vivian S Lee Journal: Am J Physiol Renal Physiol Date: 2014-01-22
Authors: Jon M Thacker; Lu-Ping Li; Wei Li; Ying Zhou; Stuart M Sprague; Pottumarthi V Prasad Journal: Invest Radiol Date: 2015-12 Impact factor: 6.016