Data on greenhouse gases emission in condensate separation unit of a petrochemical company in Iran.

Since global warming due to greenhouse gas emissions is no respecter of geographical boundaries of countries, concerted mitigation activities such as Clean Development Mechanism (CDM), are suitable. In this mechanism, some developed countries can gain certified emission reduction credits from emission reduction actions undertaken in developing countries. Thus, the data of greenhouse gas emissions in developing countries would be informative for implementing of CDM. Herein, the data of greenhouse gas emissions of Bandar Imam Petrochemical Complex, one of the biggest petrochemical companies in the Middle East region is presented. The data was acquired using emission factor method and self-presented raw information of the Bandar Imam Petrochemical Complex. Overall, the data will be interesting for environmentalists, non-governmental organization (NGO), and developed countries to perform CDM.

Specifications Table

Value of the data

This data set generally answered the question of “what is the situation of the implementation of Kyoto protocol legislations to prevent/reduce greenhouse gas emissions in companies in developing countries such as Bandar Imam Petrochemical Complex (BIPC)?”

The data will be attractive for whom with concern about global warming such as non-governmental organization (NGO).

The data of greenhouse gases estimation by emission factor in this article implicitly proposes that Bandar Imam Petrochemical Complex is good place for carbon trade and Clean Development Mechanism (CDM) implementation.

Data

Data presented here describe the greenhouse gases especially CH4 and CO2 emission from a petrochemical plant with condensate separation unit in Mahshahr, Iran. Two Tables and one figure are presented. Fig. 1 is depicts the geographical position of the Bandar Imam Petrochemical Complex (study zone). Table 1 shows emission of CH4 and CO2 and Table 2 contains the emission factors presented by different references.

Fig. 1

Geographical map of the site study.

Table 1

CH4 and CO2 emission from condensate separation unit.

Unit	Greenhouse emission		References
	CO2(Tonne/day)	CH4(Tonne/day)
Flare	–	0.25	[2]
	44.85	0.32	[3]
	–	0.05	[4]
	49.53	–	[5]
	57.85	–	[6]
	43.08	0.16	[7]
	61.12	0.005	[8]
	59.36	0.25	[9]
Gas Heater	–	0.001	[10]
	29.43	0.006
	–	0.99	[3]
Reboiler	0.15	1.38×10−6	[11]
Separators	–	0.03	[12]
Compressor station	0.004	0.01	[10]
Compressor turn on	0.03	0.53
Compressor blow down	0.10	0.24
Propane Reservoir	4.23	1.81	[10]
Butane Reservoir	4.23	1.81
Pentane Reservoir	1.88	0.80
Hexane Reservoir	0.86	0.37
Gas Valves	–	0.10	[10]
Natural Gas combustion	1718.05	–	[13]
	1683.19	–	[10]
	1683.19	0.03	[10]
	1725.38	0.03	[14]
	1686.54	–	[6]

Table 2

CH4 and CO2 emission factors.

Unit	References	Emission factors
		CO2	CH4
Flare	[2]	–	0.61 lb/MMBtu
	[3]	1853 g/m3 gas	13.6 g/m3 gas
	[4]	–	0.12 lb/MMB
	[5]	120.72 lb/MMBtu	–
	[6]	141.01 lb/MMBtu	–
	[7]	105.01 lb/MMBtu	0.39 lb/MMBtu
	[8]	148.98 lb/MMBtu	0.01 lb/MMBtu
	[9]	144.69 lb/MMBtu	0.61 lb/MMBtu
Gas Heater	[10]	–	1.1×10−6 tonne/106 Btu
	[3]	1891 g/m3	0.04 g/m3
	[12]	–	20.987 Scf /heater-yr
Re boiler	[11]	116.87 lb/MMscf	0.011 lb/MMscf
Separators	[12]	–	20171 scf/separator-yr
Compressor station	[10]	2.42*10−2 tones/vessel-yr	2.42×10−2 tones/vessel-yr
Compressor turn on		2.42*10−2 tones/vessel-yr	2.42×10−2 tones/vessel-yr
Compressor blow down		2.42*10−2 tones/vessel-yr	2.42×10−2 tones/vessel-yr
Gas Valves	[10]	–	4.5×10−6 tonne /hr/component
Heavy Oil valves		–	8.4×10−9 tonne /hr/component
Light Oil valves		–	2.5×10−6 tonne /hr/component
Valves Oil/Water		–	9.8×10−8 tonne /hr/component
Natural Gas combustion	[13]	0.05 tonne/MMBtu	–
	[10]	0.05 tonne/MMBtu	1.06×10−6 tonne/MMBtu
	[14]	120000 Lb/106scf	2.3 Lb/106scf
	[6]	0.05 tonne/MMBtu	–

Experimental design, materials and methods

The data of this article was obtained from Bandar Imam Petrochemical Complex (BIPC), with an area of 270 ha, which is located in the North West coast of the Persian Gulf. This petrochemical company is situated in Khuzestan province, Iran with 105 km southeast of Ahvaz city and 84 km East of Abadan and Mahshahr cities (see Fig. 1).

The estimation process of greenhouse gases emission involved three stages: In the first stage, a site survey with process flow diagram (PFD) study was done in September 2015 for analyzing components attributed in greenhouse gases emission in unit of separating gas condensate of Bandar imam petrochemical company. In the second stage, the emission factors provided by various organizations, which have been listed in Table 1, emissions for each sources was calculated by using Eq. (1):In this equation, E is the rate emission of greenhouse gas (the amount of greenhouse gas mass); A is the amount of activity; EF is an emission factor (the amount of greenhouse gas mass emitted per the amount of product produced or the rate activity); ER is the overall percentage reduction of emission that this value is considered to be zero, due to the lack of using greenhouse gas reduction systems [1]. Finally, the data were processed using Excel software for calculation of emission rate by formulation Eq. (1).

Subject area	Environmental Engineering
More specific subject area	Air Pollution
Type of data	Table and image
How data was acquired	Collect raw data of greenhouse gas emission from an Iranian petrochemical company.
	Use emission factor to calculate greenhouse gases
Data format	Processed, raw
Experimental factors	Processing of greenhouse gas emission data
Experimental features	Contribution of condensate separation unit of a Petrochemical Plant in Iran in greenhouse gas emission
Data source location	Mahshahr, Iran, 30°33′32″N 49°11′53″E
Data accessibility	Data is available with the article