Low-Voltage Voltammetric Electrowetting of Graphite Surfaces by Ion Intercalation/Deintercalation.

We demonstrate low-voltage electrowetting at the surface of freshly cleaved highly oriented pyrolytic graphite (HOPG). Using cyclic voltammetry (CV), electrowetting of a droplet of a sodium perchlorate solution is observed at moderately positive potentials on high-quality (low step edge coverage) HOPG, leading to significant changes in the contact angle and relative contact diameter that are comparable to the results of the widely studied electrowetting on dielectric (EWOD) system, but over a much lower voltage range. The electrowetting behavior is found to be reasonably fast, reversible, and repeatable for at least 20 cyclic scans (maximum tested). In contrast to classical electrowetting, e.g., EWOD, the electrowetting of the droplet on HOPG occurs with the intercalation/deintercalation of anions between the graphene layers of graphite, driven by the applied potential, observed in the CV response, and detected by X-ray photoelectron spectroscopy. The electrowetting behavior is strongly influenced by those factors that affect the extent of the intercalation/deintercalation of ions on graphite, such as potential range scan rate, potential polarity, quality of the HOPG substrate (step edge density and step height), and type of anion in the solution. In addition to perchlorate, sulfate salts also promote electrowetting, but some other salts do not. Our findings suggest a new mechanism for electrowetting based on ion intercalation, and the results are important to fundamental electrochemistry as well as to diversifying the means by which electrowetting can be controlled and applied.