A novel approach for biomechanical spine analysis: Mechanical response of vertebral bone augmentation by kyphoplasty to stabilise thoracolumbar burst fractures.

Kyphoplasty has been shown as a well-established technique for spinal injuries. This technique allows a vertebral bone augmentation with a reduction of morbidity and does not involve any adjacent segment immobilisation. There is a lack of biomechanical information resulting in major gaps of knowledge such as: the evaluation of the "quality" of stabilisation provided by kyphoplasty as a standalone procedure in case of unstable fracture. Our objective is to analyse biomechanical response of spine segments stabilised by Kyphoplasty and PMMA cement after experiencing burst fractures. Six fresh-frozen cadaveric spine specimens constituted by five vertebra (T11-L3) and four disks were tested. A specific loading setup has been developed to impose pure moments corresponding to loadings of flexion-extension, lateral bending and axial rotation. Tests were performed on each specimen in an intact state and post kyphoplasty following a burst fracture. Strain measurements and motion variations of spinal unit are measured by a 3D optical method. Strain measurements on vertebral bodies after kyphoplasty shows a great primary stabilisation. Comparisons of mobility and angles variations between the intact and post kyphoplasty states do not highlight significant difference. Percutaneous kyphoplasty offers a good primary stability in case of burst fracture. Kinematics analysis during physiological movements shows that this stabilisation solution preserve disk mobility in each adjacent spinal unit.