The effects of decellularization and cross-linking techniques on the fatigue life and calcification of mitral valve chordae tendineae.

In cases of severely diseased mitral valves (MV), the required treatment is often valve replacement. Bioprosthetic and stentless replacement valves are usually either fully or partially composed of animal derived tissue treated with a decellularization process, a cross-linking process, or both. In this study, we analysed the effects of these treatments on the fatigue properties of porcine MV chordae tendineae (CT), as well as on the calcification of the CT using an in vitro technique. CT were tested in 4 groups; (1) native, (2) decellularized (DC), (3) decellularized and cross-linked with glutaraldehyde (DC-GTH), and (4) decellularized and cross-linked with 1-ehtyl-3-(3-dimethylaminopropyl) carbodiimide (EDC)(DC-EDC). CT were tested in both uniaxial tension, and in fatigue at 10MPa peak stress (1Hz). The cycles to failure (mean±SD) for the four groups are as follows; Native- 53,397±55,798, DC- 28,013±30,634, DC-GTH- 97,665±133,556, DC-EDC- 318,601±322,358. DC-EDC CT were found to have a slightly longer fatigue life than the native and DC groups. The DC-EDC group also had a marginally lower dynamic creep rate, meaning those CT elongate more slowly. After in vitro calcification, X-ray microtomography was used to determine relative levels of calcification. The DC-EDC and DC-GTH groups had the lowest volume of calcific deposits. Under uniaxial testing, the ultimate tensile strength (UTS) of the DC-GTH CT was statistically significantly reduced after calcification, while the UTS was relatively unchanged for the DC-EDC group. Overall, these results indicate that a treatment of decellularization plus cross-linking with EDC may improve the fatigue life of porcine CT, reduce the rate of elongation, and help the CT resist the negative effects of calcification. This may be a preferable treatment in the preparation of porcine MVs for the replacement of diseased MVs.