| Literature DB >> 26776664 |
Satoshi Nishimoto1, Vamshi M Katukuri1, Viktor Yushankhai2,3, Hermann Stoll4, Ulrich K Rößler1, Liviu Hozoi1, Ioannis Rousochatzakis1,3, Jeroen van den Brink1,5.
Abstract
Iridium oxides with a honeycomb lattice have been identified as platforms for the much anticipated Kitaev topological spin liquid: the spin-orbit entangled states of Ir(4+) in principle generate precisely the required type of anisotropic exchange. However, other magnetic couplings can drive the system away from the spin-liquid phase. With this in mind, here we disentangle the different magnetic interactions in Li2IrO3, a honeycomb iridate with two crystallographically inequivalent sets of adjacent Ir sites. Our ab initio many-body calculations show that, while both Heisenberg and Kitaev nearest-neighbour couplings are present, on one set of Ir-Ir bonds the former dominates, resulting in the formation of spin-triplet dimers. The triplet dimers frame a strongly frustrated triangular lattice and by exact cluster diagonalization we show that they remain protected in a wide region of the phase diagram.Entities:
Year: 2016 PMID: 26776664 PMCID: PMC4735606 DOI: 10.1038/ncomms10273
Source DB: PubMed Journal: Nat Commun ISSN: 2041-1723 Impact factor: 14.919
Figure 1Honeycomb structure of Li2IrO3 and mapping onto an effective triangular lattice of triplet spins.
(a) The two distinct sets of NN links26 are labelled as B1 (along the crystallographic b axis) and B2/B3. (b) The large FM interaction J=−19.2 meV on B1 bonds stabilizes rigid T=1 triplets that frame an effective triangular lattice. The triplet dimers remain protected in a wide region of the phase diagram, including the incommensurate ICx and (c) diagonal-zigzag phase, see text. (d) Representative exchange couplings for B1 (J, K), B2/B3 (J′, K′), second neighbour (J2) and third neighbour (J3) paths on the original hexagonal grid are shown. J (∈{a, b, a−2b}) are isotropic exchange interactions on the effective triangular net.
Magnetic spectra of two adjacent Ir4+ sites and effective exchange interaction parameters in Li2IrO3.
| 0.0 | 0.0 | |
| −17.1 | 1.3 | |
| −24.8 | −3.4 | |
| −21.6 | −7.1 | |
| −19.2 | 0.8 | |
| −6.0 | −11.6 | |
| −1.1 | 4.2 | |
| −4.8 | −2.0 |
Relative energies of the four low-lying magnetic states and the associated effective exchange couplings (meV) for each of the two distinct types of (Ir2O10) units, B1 and B2/B3 (ref. 26), are shown. The energy of the singlet is taken as reference. Results of spin-orbit MRCI calculations.
*∡(Ir–O–Ir)=95.3°, d(Ir–Ir)=2.98 (× 2), d(Ir–O1,2)=2.01 Å.
†∡(Ir–O–Ir)=94.7°, d(Ir–Ir)=2.98 (× 4), d(Ir–O1)=2.08, d(Ir–O2)=1.97 Å. O1 and O2 are the two bridging O's.
Figure 2Variation of the Heisenberg and Kitaev exchange couplings with the Ir–O–Ir angle in idealized honeycomb structural models.
Results of spin-orbit MRCI calculations are shown, for NN Ir–Ir links in both Li213 (continuous lines) and Na213 (dashed). For each system, the NN Ir–Ir distances are set to the average value in the experimental crystal structure1526 and the Ir–O bond lengths are all the same. Consequently, J=J′ and K=K′. The variation of the Ir–O–Ir angles is the result of gradual trigonal compression. Note that , meV at 90°. Inset: dependence of the NN J in Li213 when the bridging O's are gradually shifted in opposite senses parallel to the Ir–Ir axis.
Figure 3Magnetic phase diagrams and spin structure factor.
Phase diagram of Li213 in the J2–J3 plane with the NN couplings listed in Table 1, along with schematic spin configurations and Bragg peak positions (red circles) for each phase. (a) Classical phase diagram of the effective spin T=1 model on the triangular lattice, found by a numerical minimization of the interaction matrix Λ(k) in the Brillouin zone (BZ). The actual ground-state configurations in the incommensurate regions ICx and ICy can be much richer than the standard coplanar helix states owing to anisotropy, see text. (b) Quantum mechanical phase diagram for the original spin-1/2 model. (c) Structure factor for representative momenta in different phases. Note that in the ICx phase, the peak position (±Q, 0) takes values between 0