| Literature DB >> 26552041 |
Shao Hsuan Tsao1, Dehui Wan1, Yu-Sheng Lai2, Ho-Ming Chang2, Chen-Chieh Yu3, Keng-Te Lin3, Hsuen-Li Chen3.
Abstract
This paper describes a systematic investigation of the phenomenon of white-light-induced heating in silk fibroin films embedded with gold nanoparticles (Au NPs). The Au NPs functioned to develop an ultrahigh broadband absorber, allowing white light to be used as a source for photothermal generation. With an increase of the Au content in the composite films, the absorbance was enhanced significantly around the localized surface plasmon resonance (LSPR) wavelength, while non-LSPR wavelengths were also increased dramatically. The greater amount of absorbed light increased the rate of photoheating. The optimized composite film exhibited ultrahigh absorbances of approximately 95% over the spectral range from 350 to 750 nm, with moderate absorbances (>60%) at longer wavelengths (750-1000 nm). As a result, the composite film absorbed almost all of the incident light and, accordingly, converted this optical energy to local heat. Therefore, significant temperature increases (ca. 100 °C) were readily obtained when we irradiated the composite film under a light-emitting diode or halogen lamp. Moreover, such composite films displayed linear light-to-heat responses with respect to the light intensity, as well as great photothermal stability. A broadband absorptive film coated on a simple Al/Si Schottky diode displayed a linear, significant, stable photo-thermo-electronic effect in response to varying the light intensity.Entities:
Keywords: broadband absorber; gold nanoparticles; photothermal effect; silk fibroin; surface plasmon resonance; white-light illumination
Mesh:
Substances:
Year: 2015 PMID: 26552041 DOI: 10.1021/acsnano.5b04913
Source DB: PubMed Journal: ACS Nano ISSN: 1936-0851 Impact factor: 15.881