Literature DB >> 26356993

Adapting SWAT hillslope erosion model to predict sediment concentrations and yields in large Basins.

Olga Vigiak1, Anna Malagó2, Fayçal Bouraoui2, Matthias Vanmaercke3, Jean Poesen4.   

Abstract

The Soil and Water Assessment Tool (SWAT) is used worldwide for water quality assessment and planning. This paper aimed to assess and adapt SWAT hillslope sediment yield model (Modified Universal Soil Loss Equation, MUSLE) for applications in large basins, i.e. when spatial data is coarse and model units are large; and to develop a robust sediment calibration method for large regions. The Upper Danube Basin (132,000km(2)) was used as case study representative of large European Basins. The MUSLE was modified to reduce sensitivity of sediment yields to the Hydrologic Response Unit (HRU) size, and to identify appropriate algorithms for estimating hillslope length (L) and slope-length factor (LS). HRUs gross erosion was broadly calibrated against plot data and soil erosion map estimates. Next, mean annual SWAT suspended sediment concentrations (SSC, mg/L) were calibrated and validated against SSC data at 55 gauging stations (622 station-years). SWAT annual specific sediment yields in subbasin reaches (RSSY, t/km(2)/year) were compared to yields measured at 33 gauging stations (87station-years). The best SWAT configuration combined a MUSLE equation modified by the introduction of a threshold area of 0.01km(2) where L and LS were estimated with flow accumulation algorithms. For this configuration, the SSC residual interquartile was less than +/-15mg/L both for the calibration (1995-2004) and the validation (2005-2009) periods. The mean SSC percent bias for 1995-2009 was 24%. RSSY residual interquartile was within +/-10t/km(2)/year, with a mean RSSY percent bias of 12%. Residuals showed no bias with respect to drainage area, slope, or spatial distribution. The use of multiple data types at multiple sites enabled robust simulation of sediment concentrations and yields of the region. The MUSLE modifications are recommended for use in large basins. Based on SWAT simulations, we present a sediment budget for the Upper Danube Basin.
Copyright © 2015. Published by Elsevier B.V.

Entities:  

Keywords:  MUSLE; Multi-site calibration; SWAT; Sediment budget; Sediment load; Upper Danube; Water erosion

Mesh:

Year:  2015        PMID: 26356993     DOI: 10.1016/j.scitotenv.2015.08.095

Source DB:  PubMed          Journal:  Sci Total Environ        ISSN: 0048-9697            Impact factor:   7.963


  2 in total

Review 1.  Modelling water and nutrient fluxes in the Danube River Basin with SWAT.

Authors:  Anna Malagó; Faycal Bouraoui; Olga Vigiak; Bruna Grizzetti; Marco Pastori
Journal:  Sci Total Environ       Date:  2017-06-17       Impact factor: 7.963

2.  Regionalization of the SWAT+ model for projecting climate change impacts on sediment yield: An application in the Nile basin.

Authors:  Albert Nkwasa; Celray James Chawanda; Ann van Griensven
Journal:  J Hydrol Reg Stud       Date:  2022-08
  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.