Literature DB >> 25933170

Effect of phytic acid etchant on the structural stability of demineralized dentine and dentine bonding.

Kalyan Kong1, Md Sofiqul Islam2, Mohannad Nassar3, Noriko Hiraishi4, Masayuki Otsuki5, Cynthia K Y Yiu6, Junji Tagami7.   

Abstract

OBJECTIVE: This study examined the effect of phytic acid (IP6) in stabilizing the morphology of dentine collagen network and resin-dentine bonding.
METHODS: Dentine beams were fully demineralized with 10% phosphoric acid (PA) or 1% IP6 (pH 1.2). PA-demineralized beams were divided into three groups: (a) no further treatment (control), (b) treatment with 5% glutaraldehyde (GA) for 1 h and (c) treatment with 1% IP6 (pH 7) for 1 h. IP6-demineralized beams received no further treatment. The beams were then subjected to ultimate tensile strength (UTS) testing. Dentine micromorphology evaluation was performed using a field-emission scanning electron microscope (FE-SEM). Dentine disks were etched with 35% PA for 15 s or 1% IP6 for 30s. PA-etched dentine disks were divided into three groups as (a), (b) and (c) as for UTS testing, but the treatment with GA or IP6 was done in 1min. For microtensile bond strength (µTBS) testing, flat dentine surfaces etched with PA or IP6 were blot-dried (wet dentine) or air-dried for 10s (dry dentine) and bonded with an etch-and-rinse adhesive followed by composite build-up.
RESULTS: IP6-demineralized dentine showed significantly higher UTS, when compared to PA-demineralized dentine. GA and IP6 significantly improved UTS of PA-demineralized dentine. FE-SEM observation revealed that dentine collagen network was preserved by GA and IP6. No significant difference in µTBS was found between the wet and dry IP6-etched dentine groups.
CONCLUSION: IP6 etching showed a structural stabilizing effect on demineralized dentine matrix and produced good resin-dentine bonding, regardless of dentine moistness or dryness.
Copyright © 2015 Elsevier Ltd. All rights reserved.

Entities:  

Keywords:  Cross-linker; Glutaraldehyde; Microtensile bond strength; Phosphoric acid; Phytic acid; Ultimate tensile strength

Mesh:

Substances:

Year:  2015        PMID: 25933170     DOI: 10.1016/j.jmbbm.2015.03.027

Source DB:  PubMed          Journal:  J Mech Behav Biomed Mater        ISSN: 1878-0180


  4 in total

Review 1.  Polyphenol uses in biomaterials engineering.

Authors:  Amin Shavandi; Alaa El-Din Ahmed Bekhit; Pouya Saeedi; Zohreh Izadifar; Adnan A Bekhit; Ali Khademhosseini
Journal:  Biomaterials       Date:  2018-03-13       Impact factor: 12.479

2.  Effect of phytic acid as an endodontic chelator on resin adhesion to sodium hypochlorite-treated dentin.

Authors:  Mohannad Nassar; Noriko Hiraishi; Md Sofiqul Islam; Maria Jrh Romero; Masayuki Otsuki; Junji Tagami
Journal:  Restor Dent Endod       Date:  2020-08-24

3.  Erosive Potential of 1% Phytic Acid on Radicular Dentine at Different Time Intervals.

Authors:  Zareen Afshan; Shahbaz Ahmed Jat; Javeria Ali Khan; Arshad Hasan; Fazal Ur Rehman Qazi
Journal:  Eur Endod J       Date:  2020-03-17

4.  Effect of smear layer removal agents on the microhardness and roughness of radicular dentin.

Authors:  Hosea Lalrin Muana; Mohannad Nassar; Ahmad Dargham; Noriko Hiraishi; Junji Tagami
Journal:  Saudi Dent J       Date:  2020-05-29
  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.