Literature DB >> 25645810

LC-MS/MS bioanalysis of loratadine (Claritin) in dried blood spot (DBS) samples collected by subjects in a clinical research study.

Wenkui Li1, John Doherty2, Paul Moench2, Jimmy Flarakos2, Francis L S Tse2.   

Abstract

A high-performance liquid chromatography-tandem mass spectrometric (LC-MS/MS) method has been developed and validated for the quantitative analysis of loratadine, an H1 histamine antagonist, in human dried blood spot (DBS) samples following a single self-administered 10 or 20mg oral dose. The samples were produced by spotting approximately 30μl of whole blood onto PE-226 cards. Two 3-mm discs were cut from the DBS samples and extracted using aqueous methanol containing the internal standard. After transfer and drying of the resulting sample extract, the reconstituted residues were chromatographed using a Waters XSelect C18 column and isocratic elution for MS/MS detection. The possible impact due to hematocrit, volume of blood sample spotted, storage temperature, and humidity, on the accuracy of measured DBS results were investigated. The results showed that only spotted blood volume might have an impact; a small volume (10μl) tended to give a larger negative bias in the measured value than the large volume ones (≥20μl). The current method was fully validated over a dynamic range of 0.200-20.0ng/ml with correlation coefficients (r(2)) for three validation batches equal to or better than 0.990. The intra-day accuracy and precision at the LLOQ were -11.5 to 0.0% bias and 6.4 to 8.9% CV, respectively. For the other QC samples (0.600, 3.00, 10.0 and 15.0ng/ml), the precision ranged from 4.2 to 9.8% CV and from 6.3 to 8.1% CV, respectively, in the intra-day and inter-day evaluations; the accuracy ranged from -1.7 to 10.0% and 2.7 to 5.3% bias, respectively, in the intra-day and inter-day batches. Loratadine is stable in the DBS samples for at least 271 days at ambient temperature in a desiccator, for at least 24h at 60°C and under 80% relative humidity, followed by re-conditioning at ambient temperature in a desiccator. The current methodology has been applied to determine the loratadine levels in DBS samples collected by subjects in a clinical research study to evaluate pharmacokinetic sampling in point-of-care setting.
Copyright © 2015 Elsevier B.V. All rights reserved.

Entities:  

Keywords:  Blood volume; Dried blood spot (DBS); Hematocrit impact; Humidity impact; LC–MS/MS; Loratadine; Point-of-care setting; Self-sampling; Stability

Mesh:

Substances:

Year:  2015        PMID: 25645810     DOI: 10.1016/j.jchromb.2014.12.033

Source DB:  PubMed          Journal:  J Chromatogr B Analyt Technol Biomed Life Sci        ISSN: 1570-0232            Impact factor:   3.205


  2 in total

Review 1.  Suggestions for Model-Informed Precision Dosing to Optimize Neonatal Drug Therapy.

Authors:  Joshua C Euteneuer; Suyog Kamatkar; Tsuyoshi Fukuda; Alexander A Vinks; Henry T Akinbi
Journal:  J Clin Pharmacol       Date:  2018-09-11       Impact factor: 3.126

2.  Advantages and Challenges of Dried Blood Spot Analysis by Mass Spectrometry Across the Total Testing Process.

Authors:  Rosita Zakaria; Katrina J Allen; Jennifer J Koplin; Peter Roche; Ronda F Greaves
Journal:  EJIFCC       Date:  2016-12-01
  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.