Literature DB >> 25477665

Yoghurt with candied chestnut: freeze drying, physical, and rheological behaviour.

Melike Sakin-Yilmazer1, S Nur Dirim1, Davide Di Pinto1, Figen Kaymak-Ertekin1.   

Abstract

As a novel product, yoghurt powder was produced by freeze drying and with added candied chestnut puree at ratios of 5, 10, and 20 % by weight. During the freeze drying process, mass loss, water activity, and the moisture content of the samples were determined and the colour (Hunter L, a, b) of the yoghurt powder products was measured. Results showed that increasing the percentage of candied chestnut puree resulted in an increase in water activity, moisture content, and colour change values of the end product. The drying behaviour, drying rate versus free moisture content, was also investigated. It was observed that yoghurt with or without added candied chestnut puree could be satisfactorily freeze-dried. Moreover, the performance of the dried product was observed in a ready-to-use, reconstituted form. For this purpose, the obtained powders were reconstituted to their original moisture contents. Shear stress and apparent viscosity against shear rate in a range of 1-1,000 (1/sec) was then measured by a Haake-Mars rotary viscometer. According to the results, the apparent viscosities of reconstituted products, as plain yoghurt and the one with an added 5 % chestnut puree were lower than that of fresh yoghurt. However, reconstituted yoghurts containing 10 % and 20 % chestnut puree had apparent viscosities higher than fresh yoghurt. Power Law explained well the rheological behaviour of reconstituted yoghurt samples for the applied shear rate range. Based on rheological data and sensory analysis, it was concluded that the freeze dried yoghurt containing 10 % (w/w) candied chestnut puree was an acceptable novel product.

Entities:  

Keywords:  Candied chestnut; Freeze-drying behaviour; Reconstitution; Rheology; Yoghurt

Year:  2012        PMID: 25477665      PMCID: PMC4252433          DOI: 10.1007/s13197-012-0890-x

Source DB:  PubMed          Journal:  J Food Sci Technol        ISSN: 0022-1155            Impact factor:   2.701


  6 in total

1.  Antioxidant capacity, polyphenolics and pigments of broccoli-cheese powder blends.

Authors:  Krishan Datt Sharma; Kathrin Stähler; Bronwen Smith; Laurie Melton
Journal:  J Food Sci Technol       Date:  2011-01-11       Impact factor: 2.701

2.  Physical properties of yoghurt powder produced by spray drying.

Authors:  Banu Koç; Melike Sakin-Yılmazer; Figen Kaymak-Ertekin; Pınar Balkır
Journal:  J Food Sci Technol       Date:  2012-02-18       Impact factor: 2.701

Review 3.  Designer foods and their benefits: A review.

Authors:  A Rajasekaran; M Kalaivani
Journal:  J Food Sci Technol       Date:  2012-05-22       Impact factor: 2.701

4.  Effect of rate of addition of starter culture on textural characteristics of buffalo milk Feta type cheese during ripening.

Authors:  Sanjeev Kumar; S K Kanawjia; Suryamani Kumar; Sunil Khatkar
Journal:  J Food Sci Technol       Date:  2011-10-19       Impact factor: 2.701

5.  Quality indices of the set-yoghurt prepared from bovine milk treated with horseradish peroxidase.

Authors:  Yan Wen; Bao-Hua Kong; Xin-Huai Zhao
Journal:  J Food Sci Technol       Date:  2012-03-27       Impact factor: 2.701

6.  Development of freeze dried synbiotic formulation using a probiotic strain of Lactobacillus plantarum.

Authors:  T Dhewa; S Pant; Vijendra Mishra
Journal:  J Food Sci Technol       Date:  2011-07-16       Impact factor: 2.701

  6 in total
  1 in total

1.  Effect of culture levels, ultrafiltered retentate addition, total solid levels and heat treatments on quality improvement of buffalo milk plain set yoghurt.

Authors:  Vijesh Yadav; Vijay Kumar Gupta; Ganga Sahay Meena
Journal:  J Food Sci Technol       Date:  2018-02-21       Impact factor: 2.701

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.