Accuracy of 3D scanners in tooth mark analysis.

The objective of this study was to compare the accuracy of contact and laser 3D scanners in tooth mark analysis. Ten dental casts were scanned with both 3D scanners. Seven linear measurements were made from the 3D images of dental casts and biting edges generated with DentalPrint© software (University of Granada, Granada, Spain). The uncertainty value for contact 3D scanning was 0.833 for the upper dental cast and 0.660 mm for the lower cast; similar uncertainty values were found for 3D-laser scanning. Slightly higher uncertainty values were obtained for the 3D biting edges generated. The uncertainty values for single measurements ranged from 0.1 to 0.3 mm with the exception of the intercanine distance, in which higher values were obtained. Knowledge of the error rate in the 3D scanning of dental casts and biting edges is especially relevant to be applied in practical forensic cases.