Investigation of change in surface area and grain size of cadmium titanate nanofibers upon annealing and their effect on oxygen sensing.

We have investigated the phase changes in CdTiO3 nanofibers as the annealing temperature of nanofibers was increased from 600 to 1200 °C. The nanofibers annealed at 600 °C were ilmenite with a very small amount of CdO. Upon annealing at 950 °C, CdO was completely removed. Annealing at 1000 °C yielded pure perovskite nanofibers, and at temperatures above 1100 °C rutile TiO2 nanofibers were obtained. Brunauer-Emmett-Teller (BET) analysis showed that with increase in annealing temperature the surface area of nanofibers was decreased. The nanofibers annealed at 600 °C have the higher surface area of ∼9.41 m(2)/g. Then oxygen sensors using CdTiO3 nanofibers annealed at 600 °C (ilmenite) and 1000 °C (perovskite) were fabricated. The sensitivity of the ilmenite nanofibers sensor was 2 times than that of the perovskite nanofibers sensor. The response and recovery times were 120 and 23 s, respectively, for the ilmenite nanofibers sensor, whereas response and recovery times were 156 and 50 s, respectively, for the perovskite nanofibers sensor. Better oxygen characteristics of ilmenite nanofibers are attributed to their large surface area and porosity. Therefore, we believe that ilmenite CdTiO3 nanofibers are potential candidates to develop practical oxygen sensors.