Evaluation of three-dimensional position change of the condylar head after orthognathic surgery using computer-aided design/computer-aided manufacturing-made condyle positioning jig.

This study was performed to evaluate the efficacy of computer-aided design/computer-aided manufacturing (CAM/CAD)-made condyle positioning jig in orthognathic surgery. The sample consisted of 40 mandibular condyles of 20 patients with class III malocclusion who underwent bilateral sagittal split ramus osteotomy with semirigid fixation (6 men and 14 women; mean age, 25 y; mean amount of mandibular setback, 5.8 mm). Exclusion criteria were patients who needed surgical correction of the frontal ramal inclination and had signs and symptoms of the temporomandibular disorder before surgery. Three-dimensional computed tomograms were taken 1 month before the surgery (T1) and 1 day after the surgery (T2). The condylar position was evaluated at the T1 and T2 stages on the axial, frontal, and sagittal aspects in the three-dimensional coordinates. The linear change of the posterior border of the proximal segment of the ramus between T1 and T2 was also evaluated in 30 condyles (15 patients), with the exception of 10 condyles of 5 patients who received mandibular angle reduction surgery. There was no significant difference in the condylar position in the frontal and sagittal aspects (P > 0.05). Although there was a significant difference in the condylar position in the axial aspect (P < 0.01), the amount of difference was less than 1 mm and 1 degree; it can be considered clinically nonsignificant. In the linear change of the posterior border of the proximal segment of the ramus, the mean change was 1.4 mm and 60% of the samples showed a minimal change of less than 1 mm. The results of this study suggest that CAD/CAM-made condyle positioning jig is easy to install and reliable to use in orthognathic surgery.