Fractionation of plant protoplast types by iso-osmotic density gradient centrifugation.

A simple effective technique for the fractionation of protoplast populations is described. Protoplasts are separated by low-speed centrifugation in an iso-osmotic, discontinuous density gradient system on the basis of differences in their buoyant densities. At a constant osmolality of 660±20 mOs/kg H2O, the gradients provide a density range from 1.017 to 1.069 g/cm(3) at 20 °C which corresponds to the buoyant densities of most protoplast types studied. Characteristics of the KMC/S-density gradient system and factors affecting the fractionation were investigated. Protoplasts were isolated from various tissues and cultivars of tobacco, barley, wheat, rye, oat and maize. Their density-dependent distribution profiles in KMC/S-gradients and their average buoyant densities were determined under standardized conditions. Great differences in the buoyant densities were found between protoplasts of different tissues. Mixed populations of two types of protoplasts, differing in buoyant density by about 15-20 mg/cm(3), were separated to give highly purified fractions. Factors affecting the buoyant densities of protoplasts have been investigated. Ploidy level and species differences did not significantly affect the fractionation profiles. However, an age-dependent variation in the average buoyant density of tobacco mesophyll protoplasts was observed. Fractionation of tobacco mesophyll protoplasts and their subsequent regeneration to plants demonstrates the practicability and physiological compatibility of the KMC/S-density gradient system under sterile conditions. The morphogenetic potential of protoplasts was not affected by the separation procedure or the gradient components.