Fluorescence spectroscopy of polynuclear aromatic compounds in environmental monitoring.

The occurrence of polynuclear aromatic compounds (PAC) in the environment and experimental techniques suitable for the detection of PAC in environmental compartments are briefly reviewed. The specific requirements for on-site andin situ environmental analysis are outlined. Particular emphasis is given to fluorescence spectroscopic techniques for the investigation of humic acid- and soil-containing samples. Some examples of studies in the literature on Shpol'skii and jet spectroscopy and on laser-induced fluorescence (OF) measurements of PAC and mineral oils are highlighted. Contaminants in the environment are usually encountered as multicomponent mixtures in very complex matrices. Total fluorescence analysis in combination with the chemometrical technique of rank annihilation factor analysis (RAFA) was employed for the evaluation of a six-component PAC mixture in toluene. It was shown that even in the presence of strong spectral overlap the qualitative identification of all compounds and the reliable quantification of five substances was possible. Results are presented from our stationary and time-resolved fluorescence investigations of the interactions between pyrene and humic acid in water. The Stern-Volmer analysis showed a significant effect of pH on the static quenching efficiency which can be explained by the pH-dependent macromolecular structure of humic acids. Preliminary results from studies of the deactivation of triplet PAC and quenching of delayed fluorescence by humic acid are reported. LIF measurements of mineral oils directly from soil surfaces and of a model oil in a soil column were performed with a fiber-optic coupled multichannel spectrometer. The fluorescence intensity/ concentration relationships were established for a crude and a fuel oil; the corresponding lower limits of detection (LOD) were determined to be 0.025 and 0.125% m/m (mass/mass percentages). These detection limits are compared with realistic oil contaminations of soils. In a soil column designed to mimic fixed-bed bioreactors the distributions of fluorescence signal intensities from a perylene-doped model oil before and after water flooding were determined. These results fromin situ measurements can provide a quantitative basis for the modelling of temporal and spatial contaminants' distributions in reactor design.