Literature DB >> 24120270

Ultrasonic flaw detection using threshold modified S-transform.

Abdessalem Benammar1, Redouane Drai, Abderrezak Guessoum.   

Abstract

Interference noising originating from the ultrasonic testing defect signal seriously influences the accuracy of the signal extraction and defect location. Time-frequency analysis methods are mainly used to improve the defects detection resolution. In fact, the S-transform, a hybrid of the Short time Fourier transform (STFT) and wavelet transform (WT), has a time frequency resolution which is far from ideal. In this paper, a new modified S-transform based on thresholding technique, which offers a better time frequency resolution compared to the original S-transform is proposed. The improvement is achieved by the introduction of a new scaling rule for the Gaussian window used in S-transform. Simulation results are presented and show correct time frequency information of multiple Gaussian echoes under low signal-to-noise ratio (SNR) environment. In addition, experimental results demonstrate better and reliable detection of close echoes drowned in the noise.
Copyright © 2013 Elsevier B.V. All rights reserved.

Keywords:  Flaw detection; Modified S-transform; Time–frequency signal analysis; Ultrasonic signal

Mesh:

Year:  2013        PMID: 24120270     DOI: 10.1016/j.ultras.2013.09.004

Source DB:  PubMed          Journal:  Ultrasonics        ISSN: 0041-624X            Impact factor:   2.890


  1 in total

1.  Flaw Detection in Highly Scattering Materials Using a Simple Ultrasonic Sensor Employing Adaptive Template Matching.

Authors:  Biao Wu; Yong Huang
Journal:  Sensors (Basel)       Date:  2021-12-30       Impact factor: 3.576

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.