Literature DB >> 23992974

Effect of increasing the protein-to-fat ratio and reducing fat content on the chemical and physical properties of processed cheese product.

T P Guinee1, D J O'Callaghan2.   

Abstract

Scientific studies indicate that the intake of dietary fat and saturated fats in the modern Western diet is excessive and contributes adversely to health, lifestyle, and longevity. In response, manufacturers of cheese and processed cheese products (PCP) are pursuing the development of products with reduced fat contents. The present study investigated the effect of altering the fat level (13.8, 18.2, 22.7, 27.9, and 32.5 g/100g) in PCP on their chemical and physical properties. The PCP were formulated in triplicate to different fat levels using Cheddar cheese, skim milk cheese, anhydrous milk fat, emulsifying salt (ES), NaCl, and water. The formulations were designed to give fixed moisture (~53 g/100g) and ES:protein ratio (0.105). The resultant PCP, and their water-soluble extracts (WSE), prepared from a macerated blend of PCP and water at a weight ratio of 1:2, were analyzed at 4d. Reducing the fat content significantly increased the firmness of the unheated PCP and reduced the flowability and maximum loss tangent (fluidity) of the melted PCP. These changes coincided with increases in the levels of total protein, water-soluble protein, water-insoluble protein, and water-soluble Ca, and a decrease in the molar ratio of water-soluble Ca to soluble P. However, both water-soluble Ca and water-soluble protein decreased when expressed as percentages of total protein and total Ca, respectively, in the PCP. The high level of protein was a major factor contributing to the deterioration in physical properties as the fat content of PCP was reduced. Diluting the protein content or reducing the potential of the protein to aggregate, and thereby form structures that contribute to rigidity, may provide a means for improving quality of reduced-fat PCP by using natural cheese with lower intact casein content and lower calcium:casein ratio, for example, or by decreasing the ratio of sodium phosphate to sodium citrate-based ES.
Copyright © 2013 American Dairy Science Association. Published by Elsevier Inc. All rights reserved.

Entities:  

Keywords:  fat; processed cheese; rheology

Mesh:

Substances:

Year:  2013        PMID: 23992974     DOI: 10.3168/jds.2013-6685

Source DB:  PubMed          Journal:  J Dairy Sci        ISSN: 0022-0302            Impact factor:   4.034


  2 in total

1.  Quantitative Three-Dimensional Imaging of Lipid, Protein, and Water Contents via X-Ray Phase-Contrast Tomography.

Authors:  Marian Willner; Manuel Viermetz; Mathias Marschner; Kai Scherer; Christian Braun; Alexander Fingerle; Peter Noël; Ernst Rummeny; Franz Pfeiffer; Julia Herzen
Journal:  PLoS One       Date:  2016-03-22       Impact factor: 3.240

2.  The Effect of Corn Dextrin on the Rheological, Tribological, and Aroma Release Properties of a Reduced-Fat Model of Processed Cheese Spread.

Authors:  Christopher N Schädle; Stephanie Bader-Mittermaier; Solange Sanahuja
Journal:  Molecules       Date:  2022-03-13       Impact factor: 4.411

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.