M Lalumiere1, D Gagnon, F Routhier, G Desroches, J Hassan, L J Bouyer. 1. Pathokinesiology Laboratory, Centre for Interdisciplinary Research in Rehabilitation of Greater Montreal, Institut de réadaptation Gingras-Lindsay-de-Montréal, Montreal, QC, Canada.
Abstract
STUDY DESIGN: Repeated cross-sectional study. OBJECTIVES: To compare the effects of rolling resistances (RRs) on handrim kinetic intensity at the non-dominant upper limb and on handrim kinetic symmetry during wheelies performed by manual wheelchair users (MWUs) with spinal cord injury (SCI). SETTING: Pathokinesiology Laboratory. METHODS:Sixteen individuals with SCI who were able to perform wheelies participated in this study. During a laboratory assessment, participants randomly performed wheelies on four RRs: natural high-grade composite board, 5-cm thick soft foam, 5-cm thick memory foam, and with the rear wheels blocked by wooden blocks. Four trials were conducted for each of the RRs. Participant's wheelchair was equipped with instrumented wheels to record handrim kinetics, whereas the movements of the wheelchair were recorded with a motion analysis system. RESULTS: The net mean and peak total forces, including its tangential and mediolateral components, were greater during take-off compared with the other phases of the wheelie, independently of RR. During take-off, the greatest net mean and peak total and tangential forces were reached with the wheels blocked. Symmetrical tangential and mediolateral force intensities were applied at the dominant and non-dominant handrims. CONCLUSION: Wheelies performed on low or moderate density foam generate similar forces at the handrim than on a natural surface and significantly less forces than with the wheels blocked. Hence, when teaching individuals with an SCI to perform a stationary wheelie, the use of low or moderate density foam represents a valuable alternative for minimizing upper limb effort and may also optimize quasi-static postural steadiness.
RCT Entities:
STUDY DESIGN: Repeated cross-sectional study. OBJECTIVES: To compare the effects of rolling resistances (RRs) on handrim kinetic intensity at the non-dominant upper limb and on handrim kinetic symmetry during wheelies performed by manual wheelchair users (MWUs) with spinal cord injury (SCI). SETTING: Pathokinesiology Laboratory. METHODS: Sixteen individuals with SCI who were able to perform wheelies participated in this study. During a laboratory assessment, participants randomly performed wheelies on four RRs: natural high-grade composite board, 5-cm thick soft foam, 5-cm thick memory foam, and with the rear wheels blocked by wooden blocks. Four trials were conducted for each of the RRs. Participant's wheelchair was equipped with instrumented wheels to record handrim kinetics, whereas the movements of the wheelchair were recorded with a motion analysis system. RESULTS: The net mean and peak total forces, including its tangential and mediolateral components, were greater during take-off compared with the other phases of the wheelie, independently of RR. During take-off, the greatest net mean and peak total and tangential forces were reached with the wheels blocked. Symmetrical tangential and mediolateral force intensities were applied at the dominant and non-dominant handrims. CONCLUSION: Wheelies performed on low or moderate density foam generate similar forces at the handrim than on a natural surface and significantly less forces than with the wheels blocked. Hence, when teaching individuals with an SCI to perform a stationary wheelie, the use of low or moderate density foam represents a valuable alternative for minimizing upper limb effort and may also optimize quasi-static postural steadiness.
Authors: Elena Bergamini; Francesca Morelli; Flavia Marchetti; Giuseppe Vannozzi; Lorenzo Polidori; Francesco Paradisi; Marco Traballesi; Aurelio Cappozzo; Anna Sofia Delussu Journal: Biomed Res Int Date: 2015-10-12 Impact factor: 3.411