Multi-mycotoxin analysis in wheat semolina using an acetonitrile-based extraction procedure and gas chromatography-tandem mass spectrometry.

A new analytical method for the rapid and simultaneous determination of ten mycotoxins including patulin, zearalenone and eight trichothecenes (nivalenol, fusarenon-X, diacetoxyscirpenol, 3-acetyl-deoxynivalenol, neosolaniol, deoxynivalenol, T-2 and HT-2) in wheat semolina has been developed and optimized. Sample extraction and purification were performed with a modified QuEChERS-based (acronym of Quick, Easy, Cheap, Effective, Rugged and Safe) procedure and determined by gas chromatography (GC) coupled to triple quadrupole instrument (QqQ). This is the first paper on the application of GC-QqQ-MS/MS to analysis of mycotoxins. Careful optimization of the gas chromatography-tandem mass spectrometry parameters was achieved in order to attain a fast separation with the best sensitivity allowing a total run time of 16 min. The validation was performed by analyzing recovery samples at three different spiked concentrations, 20, 40 and 80 μg kg(-1), with four replicates (n=4) at each concentration. Recoveries ranged from 74% to 124% and the intra-day precision and inter-day precision, expressed as relative standard deviation, were lower than 13% and 17%, respectively for all studied compounds, except for zearalenone. Limits of quantification (LOQ) were lower than 10 μg kg(-1) for all studied mycotoxins. Eight concentration levels were used for constructing the calibration curves which showed good linearity between LOQ and 100 times LOQ concentration levels (linear range). Matrix-matched calibration for applying the method in routine analysis is recommended for reliable quantitative results. The method validated was successfully applied to fifteen wheat semolina samples detecting occurrence of mycotoxins at concentrations below the maximum permissible level.