Literature DB >> 23104609

Intraoperative determinants of rotator cuff repair integrity: an analysis of 500 consecutive repairs.

Xiao L Wu1, Lisa Briggs, George A C Murrell.   

Abstract

BACKGROUND: Rotator cuff repair has a relatively high (20%-90%) chance of retears. Patients with an intact rotator cuff 6 months after surgery have better subjective and objective outcomes at 6 months and 2 years after rotator cuff repair than those who do not have an intact repair.
PURPOSE: The aim of this study was to determine if, and if so which, intraoperative factors predict an intact repair 6 months after rotator cuff repair. STUDY
DESIGN: Cohort study; Level of evidence, 3.
METHODS: The study consisted of a cohort of 500 consecutive patients who had an arthroscopic rotator cuff repair performed by a single surgeon and an ultrasound evaluation using standard protocols of the repair 6 months after surgery. Exclusion criteria included previous fracture or shoulder surgery, incomplete or partial rotator cuff repair, and concomitant arthroplasty. Rotator cuff tear size was measured intraoperatively and mapped. The quality of the tendon, tendon mobility, and repair quality were assessed and ranked based on predetermined scales (1-4) and recorded on a specifically designed form. Logistic regression analysis was performed, with cuff integrity at 6-month follow-up as the dependent variable and tear/repair factors as the independent variables.
RESULTS: The overall postoperative retear rate was 19% at 6 months. The best predictor of rotator cuff integrity was preoperative tear size (correlation coefficient, r = 0.33; P < .001). Patients with small (≤2 cm(2)) rotator cuff tears were least likely to have retears (retear rate, 10%). As the tear size increased, the retear rate increased in a linear fashion: ≤2 cm(2) (10%), 2 to 4 cm(2) (16%), 4 to 6 cm(2) (31%), 6 to 8 cm(2) (50%), and >8 cm(2) (57%). Other surgeon-ranked intraoperative assessments did correlate with retears, but the correlations were relatively weak: repair quality (r = -0.17; P < .001), tendon mobility (r = -0.15; P < .001), and tendon quality (r = -0.14; P < .01). Regression analysis showed that the retear rate at 6-month follow-up was best predicted from the preoperative tear size and the surgeon-ranked repair quality: chance of retear = 0.38 + (0.02 × tear size in cm(2)) - (0.08 × repair quality). Tendon quality and tendon mobility did not contribute significantly to this prediction.
CONCLUSION: Tear size was the best intraoperative predictor of repair integrity after rotator cuff repair, with tears less than 2 cm(2) twice as likely to heal than tears greater than 6 cm(2).

Entities:  

Mesh:

Year:  2012        PMID: 23104609     DOI: 10.1177/0363546512462677

Source DB:  PubMed          Journal:  Am J Sports Med        ISSN: 0363-5465            Impact factor:   6.202


  30 in total

1.  Variations of the micro-vascularization of the greater tuberosity in patients with rotator cuff tears.

Authors:  Nicolas Bonnevialle; Xavier Bayle; Fabrice Projetti; Matthieu Wargny; Anne Gomez-Brouchet; Pierre Mansat
Journal:  Int Orthop       Date:  2014-12-14       Impact factor: 3.075

Review 2.  Prognostic factors influencing the outcome of rotator cuff repair: a systematic review.

Authors:  Maristella F Saccomanno; Giuseppe Sircana; Gianpiero Cazzato; Fabrizio Donati; Pietro Randelli; Giuseppe Milano
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2015-07-22       Impact factor: 4.342

3.  Quantitative assessment of the supraspinatus tendon on MRI using T2/T2* mapping and shear-wave ultrasound elastography: a pilot study.

Authors:  Konstantin Krepkin; Mary Bruno; José G Raya; Ronald S Adler; Soterios Gyftopoulos
Journal:  Skeletal Radiol       Date:  2016-11-28       Impact factor: 2.199

4.  Comparison of surgical outcomes between rotator cuff repair with and without rotator interval capsular release for rotator cuff tears to prevent and improve postoperative stiffness: a meta-analysis.

Authors:  Alisara Arirachakaran; Kornkit Chaijenkij; Janisa Andrea Maljadi; Jatupon Kongtharvonskul
Journal:  Eur J Orthop Surg Traumatol       Date:  2020-05-18

5.  * Meltblown Polymer Fabrics as Candidate Scaffolds for Rotator Cuff Tendon Tissue Engineering.

Authors:  Thomas L Jenkins; Sean Meehan; Behnam Pourdeyhimi; Dianne Little
Journal:  Tissue Eng Part A       Date:  2017-09       Impact factor: 3.845

6.  Effects of age and pathology on shear wave speed of the human rotator cuff.

Authors:  Timothy G Baumer; Jack Dischler; Leah Davis; Yassin Labyed; Daniel S Siegal; Marnix van Holsbeeck; Vasilios Moutzouros; Michael J Bey
Journal:  J Orthop Res       Date:  2017-07-31       Impact factor: 3.494

Review 7.  Massive Rotator Cuff Tear: When to Consider Reverse Shoulder Arthroplasty.

Authors:  Thomas R Sellers; Adham Abdelfattah; Mark A Frankle
Journal:  Curr Rev Musculoskelet Med       Date:  2018-03

8.  Influence of patient and diagnostic parameters on reported retear rates after arthroscopic rotator cuff repair.

Authors:  Andreas M Müller; Matthias Flury; Hasan N Alsayed; Laurent Audigé
Journal:  Knee Surg Sports Traumatol Arthrosc       Date:  2017-03-02       Impact factor: 4.342

Review 9.  Scaffolds for tendon and ligament repair and regeneration.

Authors:  Anthony Ratcliffe; David L Butler; Nathaniel A Dyment; Paul J Cagle; Christopher S Proctor; Seena S Ratcliffe; Evan L Flatow
Journal:  Ann Biomed Eng       Date:  2015-02-04       Impact factor: 3.934

10.  Predictors of disease-specific quality of life after arthroscopic rotator cuff repair.

Authors:  Arjen Kolk; Nienke Wolterbeek; Kiem Gie Auw Yang; Jacco A C Zijl; Ronald N Wessel
Journal:  Int Orthop       Date:  2015-10-27       Impact factor: 3.075

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.