Literature DB >> 23031483

Riboflavin as a dentin crosslinking agent: ultraviolet A versus blue light.

Amr S Fawzy1, Lorraine I Nitisusanta, Kulsum Iqbal, Umer Daood, Jennifer Neo.   

Abstract

OBJECTIVES: To investigate the effect of photo-activation of riboflavin either by ultraviolet (UVA) or visible blue light (BL) on the biodegradation resistance, strength of demineralized dentin matrix, bond strength to dentin and resin/dentin interface morphology.
METHODS: Dentin beams were demineralized, treated with 0.1% or 1% riboflavin solution for 5min and photo-activated with UVA or BL for 20s. The ultimate tensile strength (UTS) and hydroxyproline (HYP) release were assessed after 24h collagenase challenge. For micro-tensile bond strength (μTBS) testing and resin/dentin interface morphology investigation, dentin was acid-etched, crosslinked with riboflavin and bonded with an etch-and-rinse adhesive system. Riboflavin was photo-activated separately with UVA or BL followed by photo-polymerization of the bonding resin with BL (two-step) or both riboflavin photo-activation and bonding resin photo-polymerization were done in one-step using BL.
RESULTS: Significant improvement in the UTS and biodegradation resistance against collagenase challenge was found when riboflavin was photo-activated either with UVA or BL. However, UVA showed more significant improvement compared to BL. After 4months of water-storage, both UV and BL two-step photo-activation methods significantly preserved higher values of the μTBS compared to the non-crosslinked control group, where UVA showed significantly higher μTBS than BL. SIGNIFICANCE: Although UVA most effectively activated riboflavin, visible blue light showed to be a promising substitute for UVA as it is clinically more applicable and acceptable, and still managed to increase the biodegradation resistance, enhance the mechanical properties of dentin collagen and improve and maintain the bond strength and interface integrity after short-term water storage.
Copyright © 2012 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Entities:  

Mesh:

Substances:

Year:  2012        PMID: 23031483     DOI: 10.1016/j.dental.2012.09.009

Source DB:  PubMed          Journal:  Dent Mater        ISSN: 0109-5641            Impact factor:   5.304


  14 in total

Review 1.  Mechanisms regulating the degradation of dentin matrices by endogenous dentin proteases and their role in dental adhesion. A review.

Authors:  Camila Sabatini; David H Pashley
Journal:  Am J Dent       Date:  2014-08       Impact factor: 1.522

Review 2.  Strategies to prevent hydrolytic degradation of the hybrid layer-A review.

Authors:  Leo Tjäderhane; Fabio D Nascimento; Lorenzo Breschi; Annalisa Mazzoni; Ivarne L S Tersariol; Saulo Geraldeli; Arzu Tezvergil-Mutluay; Marcela Carrilho; Ricardo M Carvalho; Franklin R Tay; David H Pashley
Journal:  Dent Mater       Date:  2013-08-14       Impact factor: 5.304

3.  [Progress on matrix metalloproteinase inhibitors].

Authors:  Jia Lingling; Wan Qianbing
Journal:  Hua Xi Kou Qiang Yi Xue Za Zhi       Date:  2017-04-01

4.  Photochemical crosslinking of caries-affected dentin combined with total- or self-etch systems.

Authors:  Yoomin Ahn; Ricardo Lamy; Cynthia L Darling; Jay M Stewart; Lilliam M Pinzon
Journal:  Am J Transl Res       Date:  2018-09-15       Impact factor: 4.060

Review 5.  Polyphenol uses in biomaterials engineering.

Authors:  Amin Shavandi; Alaa El-Din Ahmed Bekhit; Pouya Saeedi; Zohreh Izadifar; Adnan A Bekhit; Ali Khademhosseini
Journal:  Biomaterials       Date:  2018-03-13       Impact factor: 12.479

6.  Improving bonding to eroded dentin by using collagen cross-linking agents: 2 years of water storage.

Authors:  Fabiana Suelen Figueredo de Siqueira; Bruna Hilgemberg; Lucila Cristina Rodrigues Araujo; Viviane Hass; Matheus Coelho Bandeca; João Carlos Gomes; Alessandra Reis; Alessandro D Loguercio; Andres Felipe Millan Cardenas
Journal:  Clin Oral Investig       Date:  2019-06-12       Impact factor: 3.573

Review 7.  Bond Strength of Universal Adhesives to Dentin: A Systematic Review and Meta-Analysis.

Authors:  Louis Hardan; Rim Bourgi; Naji Kharouf; Davide Mancino; Maciej Zarow; Natalia Jakubowicz; Youssef Haikel; Carlos Enrique Cuevas-Suárez
Journal:  Polymers (Basel)       Date:  2021-03-07       Impact factor: 4.329

8.  In vitro analysis of riboflavin-modified, experimental, two-step etch-and-rinse dentin adhesive: Fourier transform infrared spectroscopy and micro-Raman studies.

Authors:  Umer Daood; Chan Swee Heng; Jennifer Neo Chiew Lian; Amr S Fawzy
Journal:  Int J Oral Sci       Date:  2015-06-26       Impact factor: 6.344

9.  Polyphenols and Brazilian red propolis incorporated into a total-etching adhesive system help in maintaining bonding durability.

Authors:  Isabel Cristina Celerino de Moraes Porto; Arthur Bezerra de Barros Rocha; Iverson Iago Soares Ferreira; Bruna Muritiba de Barros; Eryck Canabarra Ávila; Matheus Corrêa da Silva; Marcos Paulo Santana de Oliveira; Teresa de Lisieux Guedes Ferreira Lôbo; José Marcos Dos Santos Oliveira; Ticiano Gomes do Nascimento; Jeniffer Mclaine Duarte de Freitas; Johnnatan Duarte de Freitas
Journal:  Heliyon       Date:  2021-02-19

10.  Comparative evaluation of chlorhexidine, grape seed extract, riboflavin/chitosan modification on microtensile bond strength of composite resin to dentin after polymerase chain reaction thermocycling: An in vitro study.

Authors:  Rani Samyukta Gajjela; R Kalyan Satish; Girija S Sajjan; K Madhu Varma; T Rambabu; B H Vijaya Lakshmi
Journal:  J Conserv Dent       Date:  2017 Mar-Apr
View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.