Literature DB >> 23009204

Thermal effects of a combined irrigation method during implant site drilling. A standardized in vitro study using a bovine rib model.

Georg D Strbac1, Ewald Unger, René Donner, Manfred Bijak, Georg Watzek, Werner Zechner.   

Abstract

OBJECTIVES: The purpose of this study was to evaluate the temperature changes during implant osteotomies with a combined irrigation system as compared to the commonly used external and internal irrigation under standardized conditions.
MATERIAL AND METHODS: Drilling procedures were performed on VII bovine ribs using a computer-aided surgical system that ensured automated intermittent drilling cycles to simulate clinical conditions. A total of 320 drilling osteotomies were performed with twist (2 mm) and conical implant drills (3.5/4.3/5 mm) at various drilling depths (10/16 mm) and with different saline irrigation (50 ml/min) methods (without/external/internal/combined). Temperature changes were recorded in real time by two custom-built thermoprobes with 14 temperature sensors (7 sensors/thermoprobe) at defined measuring depths.
RESULTS: The highest temperature increase during osteotomies was observed without any coolant irrigation (median, 8.01°C), followed by commonly used external saline irrigation (median, 2.60°C), combined irrigation (median, 1.51°C) and ultimately with internal saline irrigation (median, 1.48°C). Temperature increase with different drill diameters showed significant differences (P < 0.05) regarding drill depth, confirming drill depth and time of drilling as influencing factors of heat generation. Internal saline irrigation showed a significantly smaller temperature increase (P < 0.05) compared with combined and external irrigation. A combined irrigation procedure appears to be preferable (P < 0.05) to an external irrigation method primarily with higher osteotomy depths.
CONCLUSIONS: Combined irrigation provides sufficient reduction in temperature changes during drilling, and it may be more beneficial in deeper site osteotomies. Further studies to optimize the effects of a combined irrigation are needed.
© 2012 John Wiley & Sons A/S.

Entities:  

Keywords:  bone drilling; combined irrigation; dental implants; heat generation; implant drills; implant preparation; multiple temperature sensors; thermal osteonecrosis

Mesh:

Year:  2012        PMID: 23009204     DOI: 10.1111/clr.12032

Source DB:  PubMed          Journal:  Clin Oral Implants Res        ISSN: 0905-7161            Impact factor:   5.977


  12 in total

1.  Comparison of heat production and bone architecture changes in the implant site preparation with compressive osteotomes, osseodensification technique, piezoelectric devices, and standard drills: an ex vivo study on porcine ribs.

Authors:  Nishith Bhargava; Vittoria Perrotti; Vito Carlo Alberto Caponio; Victor Haruo Matsubara; Diana Patalwala; Alessandro Quaranta
Journal:  Odontology       Date:  2022-07-19       Impact factor: 2.885

2.  The effects of irrigation volume to the heat generation during implant surgery.

Authors:  A Sindel; Ö Dereci; M Hatipoğlu; M-A Altay; Ö Özalp; A Öztürk
Journal:  Med Oral Patol Oral Cir Bucal       Date:  2017-07-01

3.  Healing at sites prepared using different drilling protocols. An experimental study in the tibiae of sheep.

Authors:  Vittorio Favero; Shigeru Sakuma; Karol Alí Apaza Alccayhuaman; Guillermo Alejandro Benedetto; Franco Bengazi; Daniele Botticelli
Journal:  PLoS One       Date:  2018-08-29       Impact factor: 3.240

4.  Comparative Analysis of the Chemical Composition and Microstructure Conformation Between Different Dental Implant Bone Drills.

Authors:  Gaetano Marenzi; Josè Camilla Sammartino; Fabio Scherillo; Carlo Rengo; Alfredo De Rosa; Vincenzo Graziano; Gianrico Spagnuolo
Journal:  Materials (Basel)       Date:  2019-06-09       Impact factor: 3.623

5.  An experimental comparative study of drilling efficiency and temperature elevation with unmodified and modified medical drills in pig tibia bone.

Authors:  Makoto Enokida; Haruhisa Kanaya; Kazutake Uehara; Masaru Ueki; Hideki Nagashima
Journal:  Heliyon       Date:  2019-08-02

6.  Influence of Drilling Technique on the Radiographic, Thermographic, and Geomorphometric Effects of Dental Implant Drills and Osteotomy Site Preparations.

Authors:  Lara Fraguas de San José; Filippo Maria Ruggeri; Roberta Rucco; Álvaro Zubizarreta-Macho; Jorge Alonso Pérez-Barquero; Elena Riad Deglow; Sofía Hernández Montero
Journal:  J Clin Med       Date:  2020-11-11       Impact factor: 4.241

7.  Comparison of peri-implant bone loss between conventional drilling with irrigation versus low-speed drilling without irrigation.

Authors:  H Pellicer-Chover; D Peñarrocha-Oltra; A Aloy-Prosper; J-C Sanchis-Gonzalez; M-A Peñarrocha-Diago; M Peñarrocha-Diago
Journal:  Med Oral Patol Oral Cir Bucal       Date:  2017-11-01

8.  Biological Evaluation of Implant Drill Made from Zirconium Dioxide.

Authors:  Yosuke Akiba; Kaori Eguchi; Nami Akiba; Katsumi Uoshima
Journal:  Clin Implant Dent Relat Res       Date:  2016-09-22       Impact factor: 3.932

9.  Infrared Thermographic Evaluation of Temperature Modifications Induced during Implant Site Preparation with Steel vs. Zirconia Implant Drill.

Authors:  Antonio Scarano; Felice Lorusso; Sammy Noumbissi
Journal:  J Clin Med       Date:  2020-01-05       Impact factor: 4.241

10.  Effects of the technique and drill design used during the osteotomy on the thermal and histological stimulation.

Authors:  Sergio Alexandre Gehrke; Tiago Luis Eliers Treichel; Jaime Aramburú Júnior; Piedad N de Aza; Juan Carlos Prados-Frutos
Journal:  Sci Rep       Date:  2020-11-26       Impact factor: 4.379

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.