Literature DB >> 22899121

Pseudo-orthogonal frequency coded wireless SAW RFID temperature sensor tags.

Nancy Saldanha1, Donald C Malocha.   

Abstract

SAW sensors are ideal for various wireless, passive multi-sensor applications because they are small, rugged, radiation hard, and offer a wide range of material choices for operation over broad temperature ranges. The readable distance of a tag in a multi-sensor environment is dependent on the insertion loss of the device and the processing gain of the system. Single-frequency code division multiple access (CDMA) tags that are used in high-volume commercial applications must have universal coding schemes and large numbers of codes. The use of a large number of bits at the common center frequency to achieve sufficient code diversity in CDMA tags necessitates reflector banks with >30 dB loss. Orthogonal frequency coding is a spread-spectrum approach that employs frequency and time diversity to achieve enhanced tag properties. The use of orthogonal frequency coded (OFC) SAW tags reduces adjacent reflector interactions for low insertion loss, increased range, complex coding, and system processing gain. This work describes a SAW tag-sensor platform that reduces device loss by implementing long reflector banks with optimized spectral coding. This new pseudo-OFC (POFC) coding is defined and contrasted with the previously defined OFC coding scheme. Auto- and cross-correlation properties of the chips and their relation to reflectivity per strip and reflector length are discussed. Results at 250 MHz of 8-chip OFC and POFC SAW tags will be compared. The key parameters of insertion loss, cross-correlation, and autocorrelation of the two types of frequency-coded tags will be analyzed, contrasted, and discussed. It is shown that coded reflector banks can be achieved with near-zero loss and still maintain good coding properties. Experimental results and results predicted by the coupling of modes model are presented for varying reflector designs and codes. A prototype 915-MHz POFC sensor tag is used as a wireless temperature sensor and the results are shown.

Entities:  

Mesh:

Year:  2012        PMID: 22899121     DOI: 10.1109/TUFFC.2012.2379

Source DB:  PubMed          Journal:  IEEE Trans Ultrason Ferroelectr Freq Control        ISSN: 0885-3010            Impact factor:   2.725


  2 in total

1.  Capability Study of Ti, Cr, W, Ta and Pt as Seed Layers for Electrodeposited Platinum Films on γ-Al₂O₃ for High Temperature and Harsh Environment Applications.

Authors:  Marietta Seifert; Erik Brachmann; Gayatri K Rane; Siegfried B Menzel; Thomas Gemming
Journal:  Materials (Basel)       Date:  2017-01-11       Impact factor: 3.623

Review 2.  A Review of Passive RFID Tag Antenna-Based Sensors and Systems for Structural Health Monitoring Applications.

Authors:  Jun Zhang; Gui Yun Tian; Adi M J Marindra; Ali Imam Sunny; Ao Bo Zhao
Journal:  Sensors (Basel)       Date:  2017-01-29       Impact factor: 3.576

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.