Literature DB >> 22644134

Stability of a charged drop near a conductor wall.

S E Mhatre1, S D Deshmukh, R M Thaokar.   

Abstract

The effect of conductor boundaries on the deformation and stability of a charged drop is presented. The motivation for such a study is the occurrence of a charged conductor drop near a conductor wall in experiments (Millikan-like set-up in studies on Rayleigh break-up) and applications (such as electrospraying, ink-jet printing and ion mass spectroscopy). In the present work, analytical (linear stability analysis (LSA)) and numerical methods (boundary element method (BEM)) are used to understand the instability. Two kinds of boundaries are studied: a spherical, conducting, grounded enclosure (similar to a spherical capacitor) and a planar conducting wall. The LSA of a charged drop placed at the center of a spherical cavity shows that the Rayleigh critical charge (corresponding to the most unstable l = 2 Legendre mode) is reduced as the non-dimensional distance ̂d = (b - a)/a decreases, where a and b are the radii of the drop and spherical cavity, respectively. The critical charge is independent of the assumptions of constant charge or constant potential conditions. The trans-critical bifurcation diagram, constructed using BEM, shows that the prolate shapes are subcritically unstable over a much wider range of charge as [Formula: see text] decreases. The study is then extended to the stability of a charged conductor drop near a flat conductor wall. Analytical theory for this case is difficult and the stability as well as the bifurcation diagram are constructed using BEM. Moreover, the induced charges in the conductor wall lead to attraction of the drop to the wall, thereby making it difficult to conduct a systematic analysis. The drop is therefore assumed to be held at its position by an external force such as the electric field. The case when the applied field is much smaller than the field due to inherent charge on the drop ((a(3)ρg)/(3ε(0)Ψ(2)) ≪ 1 is considered. The wall breaks the fore-aft symmetry in the problem, and equilibrium, predominantly prolate shapes corresponding to the legendre mode, l = 2 , are observed. The deformation increases with increasing charge on the drop. The breakup of the prolate equilibrium shapes is independent of the legendre modes of the initial perturbations. The prolate perturbations are subcritically unstable. Since the equilibrium prolate shapes cannot continuously exchange instability with equilibrium oblate shapes, an imperfect transcritical bifurcation is observed. A variety of highly deformed equilibrium oblate shapes are predicted by the BEM calculations.

Year:  2012        PMID: 22644134     DOI: 10.1140/epje/i2012-12039-4

Source DB:  PubMed          Journal:  Eur Phys J E Soft Matter        ISSN: 1292-8941            Impact factor:   1.890


  2 in total

1.  Coulomb fission: Rayleigh jets from levitated microdroplets.

Authors:  Denis Duft; Tobias Achtzehn; Rene Müller; Bernd A Huber; Thomas Leisner
Journal:  Nature       Date:  2003-01-09       Impact factor: 49.962

2.  Shape deformations of surface-charged microdroplets.

Authors:  E Giglio; B Gervais; J Rangama; B Manil; B A Huber; D Duft; R Müller; T Leisner; C Guet
Journal:  Phys Rev E Stat Nonlin Soft Matter Phys       Date:  2008-03-31
  2 in total
  1 in total

1.  A novel method for producing unequal sized droplets in micro- and nanofluidic channels.

Authors:  Ahmad Bedram; Ali Moosavi; Siamak Kazemzadeh Hannani
Journal:  Eur Phys J E Soft Matter       Date:  2015-09-11       Impact factor: 1.890

  1 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.