| Literature DB >> 22417282 |
Yanjie Li1, Sabrina Humbert, Stephen H Howell.
Abstract
<span class="abstract_title">BACKGROUND: Adverse environmental conditions produce ER stress and elicit the unfolded protein response (UPR) in plants. Plants are reported to have two "arms" of the ER stress signaling pathway-one arm involving membrane-bound transcription factors and the other involving a membrane-associated RNA splicing factor, <span class="Gene">IRE1. IRE1 in yeast to mammals recognizes a conserved twin loop structure in the target RNA.Entities:
Mesh:
Substances:
Year: 2012 PMID: 22417282 PMCID: PMC3369818 DOI: 10.1186/1756-0500-5-144
Source DB: PubMed Journal: BMC Res Notes ISSN: 1756-0500
Figure 1IRE1 recognition sites in ZmbZIP60 mRNA and predicted protein. Diagram comparing RNA secondary structure predicted from Mfold for a segment of (A) AtbZIP60 mRNA and (B) ZmbZIP60 mRNA. (C) Partial predicted protein sequence encoded by unspliced ZmbZIP60 mRNA. Splice sites are indicated by arrows and the 20b intron is underlined. The predicted TMD is indicated in italics. (D) Partial predicted protein sequence encoded by spliced ZmbZIP60 mRNA. The arrow indicates the splice junction. The novel sequence produced by the frameshift is indicated in red. The putative nuclear localization signal is underlined. (E) Diagram showing the structures of the predicted proteins encoded by unspliced and spliced ZmbZIP60 mRNAs.
Figure 2PCR assays used in this study. (A) Flanking primer (FP) assay employs primers immediately flanking the splice site, so PCR products from both the unspliced and spliced Zmbzip60 are amplified. (B) Specific primer unspliced (SPU) assay uses a primer that crosses the exon-intron boundary and is specific for detecting the unspliced form of bzip60. Specific primers spliced (SPS) assay uses a primer that crosses the exon-exon boundary and is specific for detecting the spliced form of ZmbZIP60. The specificity of the two SP assays was demonstrated by amplifying the plasmid-cloned cDNA derived from the spliced and unspliced bzip60.
Figure 3Induction of ZmbZIP60 splicing by ER stress agents. ZmbZIP60 splicing in maize seedlings was detected using a flanking primers RT-PCR assay (FP) or a specific primer assay for spliced mRNA (SPS) or unspliced mRNA (SPU). Both unspliced (slower migrating) and spliced (faster migrating) forms appear in the FP assay and the migration position of both forms is indicated by arrows. Seven-day-old seedlings were treated by (A) immersing their roots in 2.5 mM DTT solution or (B) topically spraying the seedlings with the same solution. RNA was extracted from roots and shoots. (C) Seedlings were treated with 100 μM cyclopiazonic acid (CPA) or with 5 μg/ml tunicamycin (TM). RNA was obtained from roots. Con = control (No treatment).
Figure 4Induction of ZmbZIP60 splicing under heat stress. Maize seedlings were grown at room temperature (RT) and then incubated at 42°C for the times indicated. Some of the seedlings were recovered at RT after heat treatment for 1 hour. RNA was extracted from (A) roots and (B) shoots and analyzed using the RT-PCR assays described in Figure 2. (C) Temperature dependence of the RNA splicing reaction. Seedlings were incubated at elevated temperature for the times indicated.
Figure 5ZmbZIP60 splicing during maize development. (A) Maize seedlings of various ages were heat treated at 42°C for the indicated times. ZmbZIP60 mRNA splicing was analyzed as in Figure 2. (B) Following the heat stress of seedlings for 15 minutes, the splicing of ZmbZIP60 mRNA was observed in the basal (1), transitional (2), maturing (3), mature (4) regions of the third leaf [33]. (C) Leaves were detached from a seven-day-old seedling and incubated at RT or 42°C for the times indicated. (D) The tassel was detached from a mature maize plant and sprayed with DTT or subjected to heat treatment. RNA was extracted at various times after treatment and ZmbZIP60 mRNA splicing was detected using RT-PCR assays as described in Figure 2.
Figure 6Expression of selected BIP-like genes in maize following heat (42°C) and 2.5 mM DTT treatment for the time indicated. RT-PCR assays were conducted using the gene-specific primers as indicated in Table S1.