Literature DB >> 22289676

Removal of anionic dye Congo red from aqueous solution by raw pine and acid-treated pine cone powder as adsorbent: equilibrium, thermodynamic, kinetics, mechanism and process design.

Sara Dawood1, Tushar Kanti Sen.   

Abstract

Pine cone a natural, low-cost agricultural by-product in Australia has been studied for its potential application as an adsorbent in its raw and hydrochloric acid modified form. Surface study of pine cone and treated pine cone was investigated using Fourier transform infrared (FTIR) and scanning electron microscopy (SEM). The modification process leads to increases in the specific surface area and decreases mean particle sizes of acid-treated pine cone when compared to raw pine cone biomass. Batch adsorption experiments were performed to remove anionic dye Congo red from aqueous solution. It was found that the extent of Congo red adsorption by both raw pine cone biomass and acid-treated biomass increased with initial dye concentration, contact time, temperature but decreased with increasing solution pH and amount of adsorbent of the system. Overall, kinetic studies showed that the dye adsorption process followed pseudo-second-order kinetics based on pseudo-first-order and intra-particle diffusion models. The different kinetic parameters including rate constant, half-adsorption time, and diffusion coefficient were determined at different physico-chemical conditions. Equilibrium data were best represented by Freundlich isotherm model among Langmuir and Freundlich adsorption isotherm models. It was observed that the adsorption was pH dependent and the maximum adsorption of 32.65 mg/g occurred at pH of 3.55 for an initial dye concentration of 20 ppm by raw pine cone, whereas for acid-treated pine cone the maximum adsorption of 40.19 mg/g for the same experimental conditions. Freundlich constant 'n' also indicated favourable adsorption. Thermodynamic parameters such as ∆G(0), ∆H(0), and ∆S(0) were calculated. A single-stage batch absorber design for the Congo red adsorption onto pine cone biomass also presented based on the Freundlich isotherm model equation. Copyright Â
© 2012 Elsevier Ltd. All rights reserved.

Entities:  

Mesh:

Substances:

Year:  2012        PMID: 22289676     DOI: 10.1016/j.watres.2012.01.009

Source DB:  PubMed          Journal:  Water Res        ISSN: 0043-1354            Impact factor:   11.236


  31 in total

1.  In situ co-precipitation preparation of a superparamagnetic graphene oxide/Fe3O4 nanocomposite as an adsorbent for wastewater purification: synthesis, characterization, kinetics, and isotherm studies.

Authors:  Shengyan Pu; Shengyang Xue; Zeng Yang; Yaqi Hou; Rongxin Zhu; Wei Chu
Journal:  Environ Sci Pollut Res Int       Date:  2018-04-13       Impact factor: 4.223

2.  Removal of malachite green dye from wastewater by different organic acid-modified natural adsorbent: kinetics, equilibriums, mechanisms, practical application, and disposal of dye-loaded adsorbent.

Authors:  Hou Wang; Xingzhong Yuan; Guangming Zeng; Lijian Leng; Xin Peng; Kailingli Liao; Lijuan Peng; Zhihua Xiao
Journal:  Environ Sci Pollut Res Int       Date:  2014-06-11       Impact factor: 4.223

3.  The adsorption process during inorganic phosphorus removal by cultured periphyton.

Authors:  Haiying Lu; Linzhang Yang; Sadaf Shabbir; Yonghong Wu
Journal:  Environ Sci Pollut Res Int       Date:  2014-04-15       Impact factor: 4.223

4.  Porous nano-cerium oxide wood chip biochar composites for aqueous levofloxacin removal and sorption mechanism insights.

Authors:  Shengze Yi; Yuanyuan Sun; Xin Hu; Hongxia Xu; Bin Gao; Jichun Wu
Journal:  Environ Sci Pollut Res Int       Date:  2017-01-14       Impact factor: 4.223

5.  Cereus sp. as potential biosorbent for removal of Congo red from aqueous solution: isotherm and kinetic investigations.

Authors:  K Jeyavishnu; V Alagesan
Journal:  Environ Monit Assess       Date:  2020-03-19       Impact factor: 2.513

6.  Removal of xylenol orange from its aqueous solution using SDS self-microemulsifying systems: optimization by Box-Behnken statistical design.

Authors:  Faiyaz Shakeel; Nazrul Haq; Fars K Alanazi; Ibrahim A Alsarra
Journal:  Environ Sci Pollut Res Int       Date:  2014-01-04       Impact factor: 4.223

7.  Predictive modeling of an azo metal complex dye sorption by pumpkin husk.

Authors:  Abuzer Çelekli; Hüseyin Bozkurt
Journal:  Environ Sci Pollut Res Int       Date:  2013-04-28       Impact factor: 4.223

8.  Enhancement of sorption capacity of cocoa shell biomass modified with non-thermal plasma for removal of both cationic and anionic dyes from aqueous solution.

Authors:  Brice Takam; Elie Acayanka; Georges Y Kamgang; Merlin T Pedekwang; Samuel Laminsi
Journal:  Environ Sci Pollut Res Int       Date:  2017-06-03       Impact factor: 4.223

Review 9.  Adsorptive amputation of hazardous azo dye Congo red from wastewater: a critical review.

Authors:  Nirav P Raval; Prapti U Shah; Nisha K Shah
Journal:  Environ Sci Pollut Res Int       Date:  2016-06-02       Impact factor: 4.223

10.  Predictive modeling of sorption and desorption of a reactive azo dye by pumpkin husk.

Authors:  Abuzer Çelekli; Fadime Çelekli; Erdoğan Çiçek; Hüseyin Bozkurt
Journal:  Environ Sci Pollut Res Int       Date:  2013-12-28       Impact factor: 4.223

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.