F Zicari1, B Van Meerbeek, R Scotti, I Naert. 1. Leuven BIOMAT Research Cluster, Department of Prosthetic Dentistry, School of Dentistry, Oral Pathology and Maxillo-Facial Surgery, Catholic University of Leuven, Belgium. francesca.zicari@med.kuleuven.be
Abstract
OBJECTIVES: To evaluate the effect of the length of fibre-posts(1) and type of adhesive cement(2) on the fracture resistance of endodontically treated teeth, after fatigue loading. METHODS: Eighty extracted upper pre-molars were sectioned at the CEJ and endodontically treated. After 24 h of water storage at 37°C, RelyX Posts (3M-ESPE) were cemented with Panavia F 2.0 (Kuraray) or RelyX Unicem (3M-ESPE). A standardized composite core was built. Specimens were divided into four groups depending on the post-core ratio: (A) 2/1 (control); (B) 3/2; (C) 1/1 (small diameter); (D) 1/1(large diameter) and submitted to 1,200,000 cycles using a chewing simulator (Willytech). Immediately afterwards, all specimens that survived fatigue loading were fractured using a universal loading device (Micro-tester, Instron). Data were analysed with ANOVA. RESULTS: Four percent of the specimens failed during fatigue loading. The length of the post into the root affected the fracture resistance. The statistical outcome varied according to the inclusion of specimens failed during fatigue loading. However, the control group always had the lowest fracture resistance. The type of adhesive cement did not affect the fracture resistance. A prevalence of not-repairable failures was observed in specimens restored with the longest posts, whilst shorter posts led to more repairable failures. CONCLUSIONS: Shortening the post length and the ensuing preservation of more tooth structure, offer the potential for reparability through an in-built fail safe mechanism and may thus reduce the occurrence of catastrophic failures. Copyright Â
OBJECTIVES: To evaluate the effect of the length of fibre-posts(1) and type of adhesive cement(2) on the fracture resistance of endodontically treated teeth, after fatigue loading. METHODS: Eighty extracted upper pre-molars were sectioned at the CEJ and endodontically treated. After 24 h of water storage at 37°C, RelyX Posts (3M-ESPE) were cemented with Panavia F 2.0 (Kuraray) or RelyX Unicem (3M-ESPE). A standardized composite core was built. Specimens were divided into four groups depending on the post-core ratio: (A) 2/1 (control); (B) 3/2; (C) 1/1 (small diameter); (D) 1/1(large diameter) and submitted to 1,200,000 cycles using a chewing simulator (Willytech). Immediately afterwards, all specimens that survived fatigue loading were fractured using a universal loading device (Micro-tester, Instron). Data were analysed with ANOVA. RESULTS: Four percent of the specimens failed during fatigue loading. The length of the post into the root affected the fracture resistance. The statistical outcome varied according to the inclusion of specimens failed during fatigue loading. However, the control group always had the lowest fracture resistance. The type of adhesive cement did not affect the fracture resistance. A prevalence of not-repairable failures was observed in specimens restored with the longest posts, whilst shorter posts led to more repairable failures. CONCLUSIONS: Shortening the post length and the ensuing preservation of more tooth structure, offer the potential for reparability through an in-built fail safe mechanism and may thus reduce the occurrence of catastrophic failures. Copyright Â
Authors: Vitoria Massoneto Piccolli; Carmem Silvia Pfeifer; Ana Paula Piovezan Fugolin; Marcos Cezar Pomini; Roberta Araujo de Paula Ramos; Rafael Leonardo Xediek Consani Journal: Eur Oral Res Date: 2021-05-04