Literature DB >> 22176893

Mechanism of copper surface toxicity in Escherichia coli O157:H7 and Salmonella involves immediate membrane depolarization followed by slower rate of DNA destruction which differs from that observed for Gram-positive bacteria.

S L Warnes1, V Caves, C W Keevil.   

Abstract

We have reported previously that copper I and II ionic species, and superoxide but not Fenton reaction generated hydroxyl radicals, are important in the killing mechanism of pathogenic enterococci on copper surfaces. In this new work we determined if the mechanism was the same in non-pathogenic ancestral (K12) and laboratory (DH5α) strains, and a pathogenic strain (O157), of Escherichia coli. The pathogenic strain exhibited prolonged survival on stainless steel surfaces compared with the other E. coli strains but all died within 10 min on copper surfaces using a 'dry' inoculum protocol (with approximately 10(7)  cfu cm(-2) ) to mimic dry touch contamination. We observed immediate cytoplasmic membrane depolarization, not seen with enterococci or methicillin resistant Staphylococcus aureus, and loss of outer membrane integrity, inhibition of respiration and in situ generation of reactive oxygen species on copper and copper alloy surfaces that did not occur on stainless steel. Chelation of copper (I) and (II) ionic species still had the most significant impact on bacterial survival but protection by d-mannitol suggests hydroxyl radicals are involved in the killing mechanism. We also observed a much slower rate of DNA destruction on copper surfaces compared with previous results for enterococci. This may be due to protection of the nucleic acid by the periplasm and the extensive cell aggregation that we observed on copper surfaces. Similar results were obtained for Salmonella species but partial quenching by d-mannitol suggests radicals other than hydroxyl may be involved. The results indicate that copper biocidal surfaces are effective for Gram-positive and Gram-negative bacteria but bacterial morphology affects the mechanism of toxicity. These surfaces could not only help to prevent infection spread but also prevent horizontal gene transmission which is responsible for the evolution of virulent toxin producing and antibiotic resistant bacteria.
© 2011 Society for Applied Microbiology and Blackwell Publishing Ltd.

Entities:  

Mesh:

Substances:

Year:  2011        PMID: 22176893     DOI: 10.1111/j.1462-2920.2011.02677.x

Source DB:  PubMed          Journal:  Environ Microbiol        ISSN: 1462-2912            Impact factor:   5.491


  54 in total

1.  The efficacy of different anti-microbial metals at preventing the formation of, and eradicating bacterial biofilms of pathogenic indicator strains.

Authors:  Natalie Gugala; Joe A Lemire; Raymond J Turner
Journal:  J Antibiot (Tokyo)       Date:  2017-02-15       Impact factor: 2.649

2.  Self-Disinfecting Copper Beds Sustain Terminal Cleaning and Disinfection Effects throughout Patient Care.

Authors:  Michael G Schmidt; Hubert H Attaway; Sarah E Fairey; Jayna Howard; Denise Mohr; Stephanie Craig
Journal:  Appl Environ Microbiol       Date:  2019-12-13       Impact factor: 4.792

Review 3.  Antimicrobial activity of metals: mechanisms, molecular targets and applications.

Authors:  Joseph A Lemire; Joe J Harrison; Raymond J Turner
Journal:  Nat Rev Microbiol       Date:  2013-05-13       Impact factor: 60.633

4.  Mutant Strains of Escherichia coli and Methicillin-Resistant Staphylococcus aureus Obtained by Laboratory Selection To Survive on Metallic Copper Surfaces.

Authors:  Pauline Bleichert; Lucy Bütof; Christian Rückert; Martin Herzberg; Romeu Francisco; Paula V Morais; Gregor Grass; Jörn Kalinowski; Dietrich H Nies
Journal:  Appl Environ Microbiol       Date:  2020-12-17       Impact factor: 4.792

5.  Inactivation of murine norovirus on a range of copper alloy surfaces is accompanied by loss of capsid integrity.

Authors:  Sarah L Warnes; Emma N Summersgill; C William Keevil
Journal:  Appl Environ Microbiol       Date:  2014-12-01       Impact factor: 4.792

Review 6.  The Use of Copper as an Antimicrobial Agent in Health Care, Including Obstetrics and Gynecology.

Authors:  Linda P Arendsen; Ranee Thakar; Abdul H Sultan
Journal:  Clin Microbiol Rev       Date:  2019-08-14       Impact factor: 26.132

7.  Incorporation of bactericidal poly-acrylic acid modified copper iodide particles into adhesive resins.

Authors:  Camila Sabatini; Anthony S Mennito; Bethany J Wolf; David H Pashley; Walter G Renné
Journal:  J Dent       Date:  2015-02-27       Impact factor: 4.379

Review 8.  Antibacterial and Antiviral Functional Materials: Chemistry and Biological Activity toward Tackling COVID-19-like Pandemics.

Authors:  Bhuvaneshwari Balasubramaniam; Sudhir Ranjan; Mohit Saraf; Prasenjit Kar; Surya Pratap Singh; Vijay Kumar Thakur; Anand Singh; Raju Kumar Gupta
Journal:  ACS Pharmacol Transl Sci       Date:  2020-12-29

9.  Copper Resistance of the Emerging Pathogen Acinetobacter baumannii.

Authors:  Caitlin L Williams; Heather M Neu; Jeremy J Gilbreath; Sarah L J Michel; Daniel V Zurawski; D Scott Merrell
Journal:  Appl Environ Microbiol       Date:  2016-09-30       Impact factor: 4.792

10.  Copper Reduction and Contact Killing of Bacteria by Iron Surfaces.

Authors:  Salima Mathews; Ranjeet Kumar; Marc Solioz
Journal:  Appl Environ Microbiol       Date:  2015-07-06       Impact factor: 4.792

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.