| Literature DB >> 22060911 |
J C Forrest1, M T Morgan, C Borggaard, A J Rasmussen, B L Jespersen, J R Andersen.
Abstract
Two different technologies were tested on the slaughterline for their ability to predict drip loss at 24 h, namely near infrared reflectance (NIR) and impedance measurements using a tetra polar measuring geometry at a frequency of 1000 Hz. The results demonstrate that NIR measurements (900-1800 nm) acquired during a 6 min period starting only 30 min post exsanguination through a fibre optic probe in combination with multivariate data analysis can be used for predicting drip loss 24 h after slaughter. A correlation higher than 0.8 was observed for a trial on 99 carcasses measured at a commercial slaughterhouse. The tetrapolar impedance measurements did not perform as well as NIR yielding a correlation of 0.5 with 24 h drip loss.Entities:
Year: 2000 PMID: 22060911 DOI: 10.1016/s0309-1740(99)00133-3
Source DB: PubMed Journal: Meat Sci ISSN: 0309-1740 Impact factor: 5.209