Effect of reducing the top concentration used in the in vitro chromosomal aberration test in CHL cells on the evaluation of industrial chemical genotoxicity.

A current concern with in vitro mammalian cell genotoxicity testing is the high frequency of false or misleading positive results caused in part by the past use of excessively high test concentrations. A dataset of 249 industrial chemicals used in Japan and tested for genotoxicity was analyzed. Of these, 116 (46.6%) were positive in the in vitro chromosomal aberration (CA) test, including 6 that were positive only at test concentrations >10mM. There were 59 CA-positive chemicals at test concentrations ≤ 1mM. At >1mM, 51 chemicals were CA-positive, including 13 Ames-positive chemicals, which were therefore not "missed" by the test battery. Thus, 38 potentially positive chemicals would not have been detected in the test battery if the top test concentration was limited to 1mM in CA test. Analysis of the relevance of CA results on the 38 missed chemicals was conducted based on a weight of evidence approach, including evaluations of effects of extreme culture conditions (low pH, high toxicity, or precipitation), in silico structural alert analysis, in vivo genotoxicity and carcinogenicity test data (where available), mode of action, or information from closely related chemicals. After an exhaustive review, there were four chemicals with some concern for human health risk assessment, nine with minimal concern, and the remaining 25 with negligible concern. We apply different top concentrations to the 38 missed chemicals to identify the most accurate approach for predicting the genotoxicity of industrial chemicals. Of these 2mM or 1mg/mL, whichever is higher, was the most effective in detecting these chemicals, i.e., relatively higher (8/13) or lower (17/25) detection among 13 chemicals with some or minimal concern, or 25 with negligible concern, respectively. Lower top concentration limits, 1mM or 0.5mg/mL, whichever is higher, are not as effective (2/13) for detecting these chemicals with concern. Therefore, we conclude 2mM or 1mg/mL, whichever is higher, would be an appropriate top concentration limit for testing industrial chemicals for chromosome damage.