Alterations of the surface and morphology of tetraalkyl-ammonium modified montmorillonites upon acid treatment.

The effect of short alkyl chain cations on the modification of the structure, surface and textural properties of organo-montmorillonites upon their acid treatment was investigated. Samples prepared from Ca-SAz montmorillonite and tetramethylammonium (Me(4)N(+)-), tetraethylammonium (Et(4)N(+)-), tetrapropylammonium (Pr(4)N(+)-) and tetrabutylammonium (Bu(4)N(+)-) salts were treated in 6 M HCl at 80 °C for 2-8 h and analyzed by different methods. Acid treatment of organo-montmorillonites caused gradual release of Al and Mg from the octahedral sheets and destruction of their layered structure. The extent of the changes depended significantly on the size of organo-cation. While large plate-like particles of Ca-SAz and Me(4)N-SAz were disintegrated during acid treatment and smaller fine grains were created, the morphology of Bu(4)N-SAz was modified only slightly. Pore size analysis showed generation of pore network upon organo-montmorillonites dissolution. After longer acid attack, pore volume increased and pore size distribution curves were shifted to pores with diameter above 25 Å. The surface area of acid-treated samples increased due to destruction of the montmorillonite layers and formation of the SiO(2)-rich reaction product. The highest value 475 m(2)/g was observed for Me(4)N-SAz treated 4 h. Surface area of Et(4)N-SAz, Pr(4)-SAz and Bu(4)N-SAz was 441, 419 and 293 m(2)/g, respectively, after 8 h treatment. Similar decomposition level was observed for Ca-SAz and Me(4)N-SAz, and less destruction was found for Et(4)N-SAz, Pr(4)-SAz and very low for Bu(4)N-SAz. Though Bu(4)N(+) is short alkyl chain cation, its size is large enough to cover the inner and outer surfaces of montmorillonite and thus to protect the clay layers from acid attack.