Literature DB >> 21755996

Measuring picogram per liter concentrations of freely dissolved parent and alkyl PAHs (PAH-34), using passive sampling with polyoxymethylene.

Steven B Hawthorne1, Michiel T O Jonker, Stephan A van der Heijden, Carol B Grabanski, Nicholas A Azzolina, David J Miller.   

Abstract

Passive sampling with nondepletive sorbents is receiving increasing interest because of its potential to measure freely dissolved concentrations of hydrophobic organic compounds (HOCs) at very low concentrations, as well as its potential for both laboratory use and field deployment. However, consistent approaches have yet to be developed for the majority of HOCs of environmental and regulatory interest. In the present study, a passive sampling method was developed which allows the freely dissolved concentrations of 18 parent and 16 groups of alkyl polycyclic aromatic hydrocarbons (PAHs) on the U.S. Environmental Protection Agency (USEPA)'s "PAH-34" target compound list to be measured. Commercially available 76-μm-thick polyoxymethylene (POM) was placed in sediment/water slurries and exposed for up to 126 days, with 28 days found to be sufficient to obtain equilibrium among the sediment, water, and POM phases for the target 2- to 6-ring PAHs. The POM/water partition coefficients (K(POM)) necessary to calculate freely dissolved concentrations for parent PAHs were determined in two separate laboratories (one using pure standards, and the other using coal tar/petroleum-contaminated sediments) and agreed very well. Since the so-called "16" alkyl PAHs on the PAH-34 list actually include several hundreds of isomers for which no standards exist, sediments impacted by coal tar, or spiked with a coal tar/petroleum nonaqueous phase liquid (NAPL) were also used to measure K(POM) values for each alkyl PAH cluster. The log K(POM) values ranged from ca. 3.0 to 6.2 for 2- to 6-ring parent PAHs, and correlated well with SPARC octanol/water coefficients (K(OW)) (correlation coefficient of r(2) = 0.986). However, log K(POM) values for alkyl PAHs deviated increasingly from SPARC log K(OW) values with increasing degree of alkylation. A simple empirical model that incorporates the number of carbon atoms in a PAH gave a better fit to the experimental log K(POM) values, and was used to estimate log K(POM) for alkyl PAHs that could not be directly measured. Detection limits (as freely dissolved concentrations) ranged from ca. 1 part per trillion (ng/L) for the 2-ring PAH naphthalene, down to <1 pg/L (part per quadrillion) for the 5- and 6-ring PAHs. Sorption isotherms were linear (r(2) > 0.99) over at least 4 orders of magnitude.

Entities:  

Mesh:

Substances:

Year:  2011        PMID: 21755996     DOI: 10.1021/ac201411v

Source DB:  PubMed          Journal:  Anal Chem        ISSN: 0003-2700            Impact factor:   6.986


  7 in total

1.  Ex situ determination of freely dissolved concentrations of hydrophobic organic chemicals in sediments and soils: basis for interpreting toxicity and assessing bioavailability, risks and remediation necessity.

Authors:  Michiel T O Jonker; Robert M Burgess; Upal Ghosh; Philip M Gschwend; Sarah E Hale; Rainer Lohmann; Michael J Lydy; Keith A Maruya; Danny Reible; Foppe Smedes
Journal:  Nat Protoc       Date:  2020-04-20       Impact factor: 13.491

2.  Performance of passive samplers for monitoring estuarine water column concentrations: 1. Contaminants of concern.

Authors:  Monique M Perron; Robert M Burgess; Eric M Suuberg; Mark G Cantwell; Kelly G Pennell
Journal:  Environ Toxicol Chem       Date:  2013-10       Impact factor: 3.742

3.  Equilibrium Porewater Measurement of PCBs and PAHs Using Direct Water Extraction and Comparison with Passive Sampling.

Authors:  Songjing Yan; Mandar Bokare; Upal Ghosh
Journal:  Environ Sci Technol       Date:  2022-06-27       Impact factor: 11.357

4.  Interlaboratory Study of Polyethylene and Polydimethylsiloxane Polymeric Samplers for Ex Situ Measurement of Freely Dissolved Hydrophobic Organic Compounds in Sediment Porewater.

Authors:  Guilherme R Lotufo; Mandy M Michalsen; Danny D Reible; Philip M Gschwend; Upal Ghosh; Alan J Kennedy; Kristen M Kerns; Magdalena I Rakowska; Adesewa Odetayo; John K MacFarlane; Songjing Yan; Mandar Bokare
Journal:  Environ Toxicol Chem       Date:  2022-06-22       Impact factor: 4.218

5.  Passive sampling methods for contaminated sediments: practical guidance for selection, calibration, and implementation.

Authors:  Upal Ghosh; Susan Kane Driscoll; Robert M Burgess; Michiel T O Jonker; Danny Reible; Frank Gobas; Yongju Choi; Sabine E Apitz; Keith A Maruya; William R Gala; Munro Mortimer; Chris Beegan
Journal:  Integr Environ Assess Manag       Date:  2014-02-06       Impact factor: 2.992

Review 6.  Passive sampling methods for contaminated sediments: scientific rationale supporting use of freely dissolved concentrations.

Authors:  Philipp Mayer; Thomas F Parkerton; Rachel G Adams; John G Cargill; Jay Gan; Todd Gouin; Philip M Gschwend; Steven B Hawthorne; Paul Helm; Gesine Witt; Jing You; Beate I Escher
Journal:  Integr Environ Assess Manag       Date:  2014-02-18       Impact factor: 2.992

7.  Advancing the Use of Passive Sampling in Risk Assessment and Management of Sediments Contaminated with Hydrophobic Organic Chemicals: Results of an International Ex Situ Passive Sampling Interlaboratory Comparison.

Authors:  Michiel T O Jonker; Stephan A van der Heijden; Dave Adelman; Jennifer N Apell; Robert M Burgess; Yongju Choi; Loretta A Fernandez; Geanna M Flavetta; Upal Ghosh; Philip M Gschwend; Sarah E Hale; Mehregan Jalalizadeh; Mohammed Khairy; Mark A Lampi; Wenjian Lao; Rainer Lohmann; Michael J Lydy; Keith A Maruya; Samuel A Nutile; Amy M P Oen; Magdalena I Rakowska; Danny Reible; Tatsiana P Rusina; Foppe Smedes; Yanwen Wu
Journal:  Environ Sci Technol       Date:  2018-02-28       Impact factor: 9.028

  7 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.