Literature DB >> 21340092

A first principles study of water oxidation catalyzed by a tetraruthenium-oxo core embedded in polyoxometalate ligands.

Simone Piccinin1, Stefano Fabris.   

Abstract

We present a computational study addressing the catalytic cycle of a recently-synthesized all-inorganic homogeneous catalyst capable to promote water oxidation with low overpotential and high turnover frequency [Sartorel et al., J. Am. Chem. Soc., 2008, 130, 5006; Geletii et al., Angew. Chem., Int. Ed., 2008, 47, 3896]. This catalyst consists of a tetraruthenium-oxo core [Ru(4)O(4)(OH)(2)·(H(2)O)(4)](6+)capped by two polyoxometalate [SiW(10)O(36)](8-) units. The reaction mechanism underpinning its efficiency is currently under debate. We study a reaction cycle involving four consecutive proton-coupled electron transfer (PCET) processes that successively oxidize the four Ru(IV)-H(2)O units of the initial state (S(0)) to the four Ru(V)-OH centers of the activated intermediate (S(4)). The energetics of these electrochemical processes as well as the structural and electronic properties of the reaction intermediates are studied with ab initio Density Functional Theory (DFT) calculations. After characterizing these reaction intermediates in the gas phase, we show that the solvated tetraruthenate core undergoes a solvent-induced structural distortion that brings the predicted molecular geometry to excellent agreement with the experimental X-ray diffraction data. The calculated electronic properties of the catalyst are instead weakly dependent on the presence of the solvent. The frontier orbitals of the initial state as well as the electronic states involved in the PCET steps are shown to be localized on the tetraruthenium-oxo core. The reaction thermodynamics predicted for the intermediate reaction steps is in good agreement with the available cyclic voltammetry measurements up to S(3), but the calculated free energy difference between the initial and the activated state (S(0)/S(4)) turns out to be significantly lower than the thermodynamic limit for water oxidation. Since the oxidizing power of the S(0)/S(4) couple is not sufficient to split water, we suggest that promoting this reaction would require cycling between higher oxidation states. This journal is © the Owner Societies 2011

Entities:  

Year:  2011        PMID: 21340092     DOI: 10.1039/c0cp01915a

Source DB:  PubMed          Journal:  Phys Chem Chem Phys        ISSN: 1463-9076            Impact factor:   3.676


  2 in total

1.  Water oxidation surface mechanisms replicated by a totally inorganic tetraruthenium-oxo molecular complex.

Authors:  Simone Piccinin; Andrea Sartorel; Giuliana Aquilanti; Andrea Goldoni; Marcella Bonchio; Stefano Fabris
Journal:  Proc Natl Acad Sci U S A       Date:  2013-03-11       Impact factor: 11.205

Review 2.  The Reactivity and Stability of Polyoxometalate Water Oxidation Electrocatalysts.

Authors:  Dandan Gao; Ivan Trentin; Ludwig Schwiedrzik; Leticia González; Carsten Streb
Journal:  Molecules       Date:  2019-12-31       Impact factor: 4.411

  2 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.