Literature DB >> 21300249

Comparison of the force systems of 3 appliances on palatally impacted canines.

Sumit Yadav1, Jie Chen, Madhur Upadhyay, Feifei Jiang, W Eugene Roberts.   

Abstract

INTRODUCTION: Although much imaging research has focused on the localization and the management of impacted canines, optimal biomechanics for successful recovery are not clear. The purpose of this research was to compare the 3 mechanics--Kilroy spring, elastic chain, and steel ligature wire--used for the management of impacted canines by quantifying the 6 components of force systems involved with each system.
METHODS: A dentoform model was modified to simulate a palatally impacted canine. Load cells installed in the dentoform simultaneously measured the 3 forces (Fx, Fy, Fz) and the 3 moments (Tx, Ty, Tz) on the canine. The activation range and force system attenuation as the canine moved were also measured. The results were analyzed statistically.
RESULTS: The Kilroy spring has an activation range of 13 mm (Fz), the elastic chain has an activation range of 12 mm (Fz), and the ligature wire has an activation range of 1 mm (Fz). The full range of the elastic chain cannot be used because of its limited elastic behavior.
CONCLUSIONS: The 3-dimensional force system for canine recovery mechanics can be quantified by using these devices. Quantification of the force system provides critical information for appropriate selection of an optimal appliance.
Copyright © 2011 American Association of Orthodontists. Published by Mosby, Inc. All rights reserved.

Entities:  

Mesh:

Year:  2011        PMID: 21300249     DOI: 10.1016/j.ajodo.2009.04.027

Source DB:  PubMed          Journal:  Am J Orthod Dentofacial Orthop        ISSN: 0889-5406            Impact factor:   2.650


  4 in total

1.  Force system generated by elastic archwires with vertical V bends: a three-dimensional analysis.

Authors:  Madhur Upadhyay; Raja Shah; Donald Peterson; Takafumi Asaki; Sumit Yadav; Sachin Agarwal
Journal:  Eur J Orthod       Date:  2017-04-01       Impact factor: 3.075

2.  Evaluation of the load system produced by a single intrusion bend in a maxillary lateral incisor bracket with different alloys.

Authors:  Ricardo Lima Shintcovsk; Roberto Soares da Silva Júnior; Larry White; Lidia Parsekian Martins; Renato Parsekian Martins
Journal:  Angle Orthod       Date:  2018-05-15       Impact factor: 2.079

3.  The MH-WIRE, a novel coil-springe wire system: A prototype design.

Authors:  Mohamed A Elkolaly; Hasan S Hasan
Journal:  J Orthod Sci       Date:  2022-08-24

4.  Does muscular activity related to vertical facial divergence influence the time needed for orthodontic extrusion of palatally impacted maxillary canines? A retrospective study.

Authors:  Michele Tepedino; Maciej Iancu-Potrubacz; Cristina Grippaudo; Claudio Chimenti; Giuseppina Laganà
Journal:  J Clin Exp Dent       Date:  2018-09-01
  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.