OBJECTIVE: To compare the influence of four systems for dental bleaching on the shear bond strength (SBS) of orthodontic brackets. MATERIALS AND METHODS: One-hundred and fifty freshly extracted bovine teeth were randomly divided into five groups. In group I the teeth were untreated (control). In the remaining groups the teeth were bleached, as follows: group II: 38% hydrogen peroxide; group III: 10% carbamide peroxide; group IV: resin-based coating material (RBCM), Beauty Coat; and group V: RBCM, White Coat. In all groups the enamel was conditioned with a self-etching primer and brackets were bonded with composite resin. Samples were stored (37°C, 24 hours), tested, and statistically analyzed, with significance predetermined at P ≤ .05. The adhesive remnant index (ARI) was also evaluated and analyzed. RESULTS: The SBS of group V (22.49 ± 5.34 MPa) was significantly higher than that of all other groups (I: 17.1 ± 5.11 MPa; II: 14.72 ± 5.42 MPa; III: 12.04 ± 5.29 MPa; and IV: 18.23 ± 5.58 MPa). In contrast, the SBS of group III was significantly lower than that of all groups (except group II). Significant differences in the ARI scores were present between groups. CONCLUSIONS: The use of RBCM for dental bleaching before bonding orthodontic brackets did not reduce the SBS. In contrast, hydrogen and carbamide peroxides negatively affected the SBS. The SBS yielded after bleaching with carbamide peroxide was significantly lower.
OBJECTIVE: To compare the influence of four systems for dental bleaching on the shear bond strength (SBS) of orthodontic brackets. MATERIALS AND METHODS: One-hundred and fifty freshly extracted bovine teeth were randomly divided into five groups. In group I the teeth were untreated (control). In the remaining groups the teeth were bleached, as follows: group II: 38% hydrogen peroxide; group III: 10% carbamide peroxide; group IV: resin-based coating material (RBCM), Beauty Coat; and group V: RBCM, White Coat. In all groups the enamel was conditioned with a self-etching primer and brackets were bonded with composite resin. Samples were stored (37°C, 24 hours), tested, and statistically analyzed, with significance predetermined at P ≤ .05. The adhesive remnant index (ARI) was also evaluated and analyzed. RESULTS: The SBS of group V (22.49 ± 5.34 MPa) was significantly higher than that of all other groups (I: 17.1 ± 5.11 MPa; II: 14.72 ± 5.42 MPa; III: 12.04 ± 5.29 MPa; and IV: 18.23 ± 5.58 MPa). In contrast, the SBS of group III was significantly lower than that of all groups (except group II). Significant differences in the ARI scores were present between groups. CONCLUSIONS: The use of RBCM for dental bleaching before bonding orthodontic brackets did not reduce the SBS. In contrast, hydrogen and carbamide peroxides negatively affected the SBS. The SBS yielded after bleaching with carbamide peroxide was significantly lower.
Authors: Julio Pedra e Cal-Neto; Felipe Carvalho; Rhita Cristina C Almeida; José Augusto M Miguel Journal: Angle Orthod Date: 2006-05 Impact factor: 2.079