Potential for biofilm development in drinking water distribution systems.

Regrowth of micro-organisms in drinking water distribution systems is caused by the utilisation of biodegradable compounds which are either present in treated water or originate from materials in contact with drinking water. In the Netherlands most drinking water is distributed without disinfectant residual and regrowth is limited by achieving biostable drinking water. A combination of methods is used to assess the biostability of drinking water. These methods are: (1) determination of the concentration of easily assimilable organic carbon (AOC); and (2) assessment of the biofilm formation rate (BFR). Assimilated organic carbon concentrations in drinking water in the Netherlands range from a few μg C/l in slow sand filtrates and in ground water supplies to values of ∼ 50 μg C/l in supplies using ozonation in water treatment. Biofilm formation rate values were found to range from < 1 pg ATP/cm(2)/d in supplies using anaerobic ground water as the source. Increase of heterotrophic plate counts is limited at AOC values below 10 μg C/l. At BFR values below 10 pg ATP/cm(2)/d the risk of exceeding the guideline value for aeromonads (90 percentile < 200 c.f.u./100 ml) is less than 20%. Calculations based on the decrease of the AOC concentration observed in distributions systems confirm that very low concentrations of AOC can cause considerable biofilm formation on the pipe wall. The methods for assessing the biostability of drinking water combine with the assessment of the Biofilm Formation Potential of materials in contact with drinking water, thus providing a framework, the Unified Biofilm Approach, for evaluating the biostability of drinking water and materials. 1998 Society of Applied Microbiology.