PURPOSE: This study evaluated the adhesive quality of simplified self-adhesive and conventional resin cementsto Y-TZP in dry and aged conditions. METHODS:Y-TZP ceramic blocks (N = 192) (5 x 5 x 2 mm) were embedded in acrylic resin and randomly divided into two groups, based on surface conditioning: 96% isopropanol or chairside tribochemical silica coating and silanization. Conditioned ceramics were divided into four groups to receive the resin cements (Panavia F 2.0, Variolink II, RelyX U100 and Maxcem). After 24 hours, half of the specimens (n = 12) from each group were submitted to shear bond strength testing (0.5 mm/minute). The remaining specimens were tested after 90 days of water storage at 37 degrees C and thermocycling (12,000x, 5 degrees C-55 degrees C). Failure types were then assessed. The data were analyzed using three-way ANOVA and the Tukey's test (alpha = 0.05). RESULTS: Significant effects of ceramic conditioning, cement type and storage conditions were observed (p < 0.0001). The groups cleaned using alcohol only showed low bond strength values in dry conditions and the bond strength was reduced dramatically after aging. Groups conditioned using silica coating and silanization showed higher bond strengths both in dry and aged conditions. A high number of specimens failed prematurely prior to testing when they were cleaned using 96% isopropanol. CONCLUSION:Overall, silica coating and silanization showed higher, stable bond strengths with and without aging. The durability of resin-ceramic adhesion varied, depending on the adhesive cement type.
RCT Entities:
PURPOSE: This study evaluated the adhesive quality of simplified self-adhesive and conventional resin cements to Y-TZP in dry and aged conditions. METHODS:Y-TZP ceramic blocks (N = 192) (5 x 5 x 2 mm) were embedded in acrylic resin and randomly divided into two groups, based on surface conditioning: 96% isopropanol or chairside tribochemical silica coating and silanization. Conditioned ceramics were divided into four groups to receive the resin cements (Panavia F 2.0, Variolink II, RelyX U100 and Maxcem). After 24 hours, half of the specimens (n = 12) from each group were submitted to shear bond strength testing (0.5 mm/minute). The remaining specimens were tested after 90 days of water storage at 37 degrees C and thermocycling (12,000x, 5 degrees C-55 degrees C). Failure types were then assessed. The data were analyzed using three-way ANOVA and the Tukey's test (alpha = 0.05). RESULTS: Significant effects of ceramic conditioning, cement type and storage conditions were observed (p < 0.0001). The groups cleaned using alcohol only showed low bond strength values in dry conditions and the bond strength was reduced dramatically after aging. Groups conditioned using silica coating and silanization showed higher bond strengths both in dry and aged conditions. A high number of specimens failed prematurely prior to testing when they were cleaned using 96% isopropanol. CONCLUSION: Overall, silica coating and silanization showed higher, stable bond strengths with and without aging. The durability of resin-ceramic adhesion varied, depending on the adhesive cement type.
Authors: María Vicente Prieto; Ana Luisa Caseiro Gomes; Javier Montero Martín; Alfonso Alvarado Lorenzo; Vicente Seoane Mato; Alberto Albaladejo Martínez Journal: J Lasers Med Sci Date: 2016-10-27
Authors: Paula C K Carvalho; Cláudia C M S Almeida; Rodrigo O A Souza; Rubens Nisie Tango Journal: Materials (Basel) Date: 2022-08-08 Impact factor: 3.748